Amazon Plasma Cutter for CrossFire XR or Pro - BestArc BTC500XP CNC

Поделиться
HTML-код
  • Опубликовано: 12 дек 2024

Комментарии • 12

  • @zolcsixyz9973
    @zolcsixyz9973 День назад

    The best explanation I heard about the THC, thank you

  • @bear4380
    @bear4380 10 дней назад

    Great video. Can tell you you were impressed by that plasma cutter.

  • @joshchamberlain9413
    @joshchamberlain9413 17 дней назад +1

    I just got the same bestarc for my cnc table. Using it on my crossfire pro and an arcdroid with great results.

    • @ntdracing
      @ntdracing  17 дней назад

      @@joshchamberlain9413 I was shocked at the cut quality. It may not last as long as a High end plasma cutter, but you can buy 10 for the same price. Thanks for the feedback.

  • @mattvelardes8072
    @mattvelardes8072 18 дней назад

    A plasma table is on my wishlist.

    • @ntdracing
      @ntdracing  18 дней назад

      @@mattvelardes8072 worth the investment.

  • @westleyworley1731
    @westleyworley1731 18 дней назад

    Haven't watched the video yet, but I wanted to ask where you purchase your steel from! I have a 1.75" OD bumper I want to build but finding out that DOM is EXPENSIVE!

    • @ntdracing
      @ntdracing  18 дней назад

      @@westleyworley1731 In Colorado I use Western Steel or Reliance. I get DOM from Reliance for a better price. DOM is crazy expensive. You can probably use welded seam for a bumper. I normally only use DOM for the roll cage to comply with race regulations.

    • @westleyworley1731
      @westleyworley1731 18 дней назад

      @ntdracing That was going to be my next question! I was hoping I could get away with welded. My bender will do .120 wall, but I think it's more cost effective for .095. What are your thoughts on the rigidity between the two?

    • @ntdracing
      @ntdracing  18 дней назад

      @ depends on design. If you design in triangles where you are putting loads into compression or tension, it will be strong. If you are relying on resistance to bending, it will not.

    • @ntdracing
      @ntdracing  18 дней назад

      @@westleyworley1731 ruclips.net/video/NBdqkw_FxNo/видео.htmlsi=8nE_FWwo2IPai9zr. The bumper I made in this video was very strong…except for the ends.

    • @ntdracing
      @ntdracing  18 дней назад

      @@westleyworley1731 when in doubt…make a triangle.