@@carlosherrera9188 I didn’t measure the exact size afterwards, I just knew it was going to open it up to the 100mm I needed. 4 1/4 inches equals about 108mm. They should go on, however you could look into some hub centric rings since it’s a little bigger. Not by much something to look into to.
Keep working on the frontier I have the same one and trying to have it like yours
Thank you! 💯
Center bore just 2 be ok front only.
For the 5 spoke what would you bore them at if it was on the hardbody ? Like how deep n wide ?
Same thing for all Titan wheels
I got the 5 spokes but I have to bore them on my hardbody I just don’t know the measurements
Same as these
Where did you get those rims??
Locally on marketplace
is this the same for escalades?
Same process, but I think the opening is a different size so might need a different bit. Not 100% sure on that
Hey what size tires you go with
These are 235/40/18
Thanks
Where do i find those wheels?
These came off a Titan
What was your final bore size I used this bit in the ram wheels and my opening was 4 1/4 inches idk if it will work
@@carlosherrera9188 I didn’t measure the exact size afterwards, I just knew it was going to open it up to the 100mm I needed. 4 1/4 inches equals about 108mm. They should go on, however you could look into some hub centric rings since it’s a little bigger. Not by much something to look into to.