How to route USB data lines on a PCB

Get your free Ultimate Guide - How to Develop and Prototype a New Electronic Hardware Product: predictabledesigns.com/guide
And get your other free guides:
From Prototype to Production with the ESP32: predictabledesigns.com/esp32
From Arduino Prototype to Mass Production: predictabledesigns.com/from-a...
From Raspberry Pi Prototype to Mass Production: predictabledesigns.com/rpi
Prevent mistakes by downloading my DESIGN REVIEW CHECKLISTS for the schematic circuit, PCB layout, and enclosure 3D model design: predictabledesigns.com/design...
Want my personal help on your project? If so, check out my Hardware Academy program: predictabledesigns.com/Academy

[@mohammedhafiz8132]

Honestly, I recharged my motivation again by your video. thanks alot

[@PredictableDesigns]

Happy to hear that!

[@diogocarvalho2934]

Could you make a tutorial on USB Power Delivery and ic's to use to configure it?

[@ami6packs]

Please make a video on can bus.

[@Snowfats]

thanks!

[@fedimakni1200]

How the calculation will change if you fill the top layer with ground?

[@PredictableDesigns]

You would need to use a different calculator that includes a top layer ground plane. Same is true for an antenna feed line. Without top ground plane it's called a microstrip, but with top ground it's called a coplanar waveguide.

[@zviper]

can i route other traces under the usb data lines on layer 3 or 4? not data just some 5v power and 3.3v pwm signal. The usb in my case is only needed during programming.

[@PredictableDesigns]

Yes that should be fine.

[@tarasaurus24]

I’m routing usb signals today for the first time what luck this video came out this weeks 🥹