I know what the setup is for testing steel but when I have the Nortec 600 set and ready to start and I touch the part being tested I get a reading all over the screen and not like the reference standard. What am I missing on setting this up to read correctly?
Hi there, If the issue is urgent, we'd recommend contacting us directly: bit.ly/2pwNE3l. If you have an email address where we can reach you, we can have our technical support team contact you faster. Thanks!
I know what the setup is for testing steel but when I have the Nortec 600 set and ready to start and I touch the part being tested I get a reading all over the screen and not like the reference standard. What am I missing on setting this up to read correctly?
Lovely... :] i need this one..
Can you post a video on using NORTEC 600D for inspection of Heat Exchanger Tubes (in differential mode) ..... Please its URGENT.
Hi there, If the issue is urgent, we'd recommend contacting us directly: bit.ly/2pwNE3l. If you have an email address where we can reach you, we can have our technical support team contact you faster. Thanks!
Best
Aaaaaggggh😢 complication
It good to use with master pice for calibration only, But not goog with real work hahaha
u got it haha