Hi thank you for your video. I have SOL HOLD andALT POWER light and I had fault engine overheating and it shut off unit couple of times but it starts and runs and stops after some time. Maybe you had experience with issues like this. Thank you. Vj.
@@vjm6238 check the oil level and make sure it’s at the correct level. Also look for antifreeze pooling on the ground under the APU. Could be a bad water pump causing the overheating problem.
Need to crack open the nut running into the top of the injector and crank the motor. As your doing that watch for air coming out. Do this until it’s noting but a solid stream of fuel. Then retighten the nut.
Good video Tim. Very informative, and these are the type of videos drivers out there look for. Good job.
Very detailed video, gonna try and fix my apu, hopefully I can get it working and save some money
Good video Tim
Hi thank you for your video. I have SOL HOLD andALT POWER light and I had fault engine overheating and it shut off unit couple of times but it starts and runs and stops after some time. Maybe you had experience with issues like this. Thank you. Vj.
@@vjm6238 check the oil level and make sure it’s at the correct level. Also look for antifreeze pooling on the ground under the APU. Could be a bad water pump causing the overheating problem.
Which lighs should be on during normal operation?I got sol hold and alt power light on, does it mean my alternator is bad?
@@nikoz4841just had the same situation and two lights come on. What did you do to fix it?
How would you go about bleeding the fuel line?
Need to crack open the nut running into the top of the injector and crank the motor. As your doing that watch for air coming out. Do this until it’s noting but a solid stream of fuel. Then retighten the nut.
SUPER THANK YOU.....
Ccu main breaker tripped unknown how to fix it any suggestions
@@Truckerjj1 you’ll need to take the bottom cabinet off. Under there is a reset switch. It’ll be a red button.
@@Truckingwithcooper45 did that after watching the video still tripping it I guess I need to replace circuit board
@@Truckerjj1 check the main connection at the battery. Sounds like a ground issue
Good tip
Mines is full of oil, it will run for about 30 minutes then it will shut off with an oil light. Any idea what that might be?
@@twothumbs8925 possibly the oil sending unit sensor. Should be located on oil filter housing.
@ thanks for the info
U should make a video on how to do orientation since ur a orientation specialist
Maybe I should
Everything is fine except the AC unit won’t come on. APU running and controller is on inside bunk, AC or heat unit won’t start up
I have the same issue did you get it resolved?
Check fuses
What about no fuel pressure
That would indicate a failed fuel pump.
Put a rock on the fuel pedal and idle the truck