We custom made the header and tubes for easy removal. Just a silicon hose connector no clamps. You could probably just cut your off and add the hose so you can remove them.
2” stainless pipe. With a piece of 1/2 stainless pipe welded into it at each bay. One of theses on both ends of the Evaporater as my pipes are 5” each coming in from both front and back. So they are easier to handle. As ally of time they only plug on one end or the other.
I wish I could get to the air tubes on the piggyback like that !
We custom made the header and tubes for easy removal. Just a silicon hose connector no clamps. You could probably just cut your off and add the hose so you can remove them.
I think you were doing this the last time I saw you
Yeah it is a few times a season deal. I had them soaking all summer hoping it would pop some of the crud off. It really didn’t
How did you make the header? Looking to make the same setup on my rig, stainless tubes creating agitation
2” stainless pipe. With a piece of 1/2 stainless pipe welded into it at each bay.
One of theses on both ends of the Evaporater as my pipes are 5” each coming in from both front and back. So they are easier to handle. As ally of time they only plug on one end or the other.
@@chadsharrow9269 what size hole did you use in the 1/2” pipe?
@@kirklightcap306 1/16