Don Smith

In the video I made a mistake the H selection is for Halls and it's either ON or OFF . The controller described is used to run 3 phase motors with or without Hall sensors. My setup uses 2 halls I tried 3 but got an error1. Hall A & B or B & C work fine. When you turn the pot CCW then motor will vibrate a tiny bit then rotate either CW or CCW depending on the Phase connections. by swapping two phases and it will reverse direction. At 256 RPMs The entire system draws 160 to 170 milliamps from the 120vac input. I did check the voltage at this RPMs and got about 50VAC Peek per 4 coils in series. I have a total of 96 coils to use for loads or trying to make this self running. The voltage is available not sure about the current 200ma at 120vac will run it. I have additional coil panels available that could be added 48 coils per panel. When the pot was turned down the gen continued to spin for quite a long time lots of mass.

[@Timtron432]

Fantastic video!

[@EnterTheRealm]

Awesome 😊

[@iseeyou7622]

Hi there, Would you know who manufactures these controllers?

[@CAPTAINSSBN]

Zombies

[@iseeyou7622]

@@CAPTAINSSBN i can't find anything to do with this controller searching a company named "Zombies"

[@iseeyou7622]

Isn't this controller only have a max of 9 pole setting?

[@CAPTAINSSBN]

8 max

[@CAPTAINSSBN]

I think

[@CAPTAINSSBN]

It will auto truncate if you try more

[@iseeyou7622]

Thank you for your response. So just select 8? And it will automatically run a 36 pole? The one I'm looking at says it is capable of 20000rpm I'd be happy to hit 1500

[@CAPTAINSSBN]

It won't allow that number sure 8 max