Hello! Thank you for uploading the Chinese made BRS12A ignition test. I noticed a few things, but first I thought there was less pumping. The pressure doesn't increase until about 20 times. Next, I think it's a good idea to put some oil in the pump cup when you set it up. Preheat is enough. Although it's a bit noisy, I think it's an easy-to-use stove, so I'd like you to get used to how to use it. thank you.
Tighten the air release valve under fuel tank cap, put more pressure (30 strokes at least) and do not burn alcohol, use unleaded gasoline or naphta or white gas. 15 seconds priming must be more than enough or more if you are outside and in cold weather.
I don’t think the stove was pumped enough. Also I think it runs better on gasoline. Also was there enough fuel in the tank? Mainly think stove wasn’t pressurized properly
Habe ein ähnliches Modell auf eBay gekauft. Funktioniert mit Benzin brauchbar, mit Diesel sehr rußig. Und: Die weiße Matte unterhalb des Brenners sieht verdächtig nach Chrysotil (Weißasbest) aus, das nutzen die in Fernost exzessiv, und führen es illegalerweise auch in die EU ein. Habe es entfernt.
8 years ! that's awesome, i bought it last month and tried it petrol, it worked great too, showing blue flames, .. did you have any mechanical problems with it? .. because i want to get spare parts before hand just incase
@@just4all1 yes dear, more than 8 years I have used it. There is no machencial issue with it, keep cleaning the wire inside generator, the pipe above flames, if jet is blocked, which is blocked mostly by petrol, just open is, put WD40 in it, leave it in it and then clean it. Petrol gives problem in high altitude, Kerosene runs best in it.
@@danielmitchell5814 thank you brother for getting back to me, and for the advices, much appreciated 👍, I'll make sure I'll take good care of it for years to come,
Hello! Thank you for uploading the Chinese made BRS12A ignition test. I noticed a few things, but first I thought there was less pumping. The pressure doesn't increase until about 20 times. Next, I think it's a good idea to put some oil in the pump cup when you set it up. Preheat is enough. Although it's a bit noisy, I think it's an easy-to-use stove, so I'd like you to get used to how to use it. thank you.
Tighten the air release valve under fuel tank cap, put more pressure (30 strokes at least) and do not burn alcohol, use unleaded gasoline or naphta or white gas. 15 seconds priming must be more than enough or more if you are outside and in cold weather.
I use alcohol to ignite and gasoline in the tank and it always works awesome
Don't post a video before you learn to operate the stove. It's maddening to watch.
Gicle very tight, exchange 0.33mm to 0.65mm, só, you can use ethanol
It's true.
I don’t think the stove was pumped enough. Also I think it runs better on gasoline. Also was there enough fuel in the tank? Mainly think stove wasn’t pressurized properly
problem was with fuel, I used wrong fuel, needed to use kerosene or petrol
Please change the alcohol nozzle. It will big enough for alcohol. Can not use fuel nozzle for alcohol because it very small
Habe ein ähnliches Modell auf eBay gekauft. Funktioniert mit Benzin brauchbar, mit Diesel sehr rußig. Und: Die weiße Matte unterhalb des Brenners sieht verdächtig nach Chrysotil (Weißasbest) aus, das nutzen die in Fernost exzessiv, und führen es illegalerweise auch in die EU ein. Habe es entfernt.
I am using it from 8 years, it burns best on Kerosene. Petrol is also fine but petrol is highly flammable.
thanks
8 years ! that's awesome, i bought it last month and tried it petrol, it worked great too, showing blue flames, .. did you have any mechanical problems with it? .. because i want to get spare parts before hand just incase
@@just4all1 yes dear, more than 8 years I have used it. There is no machencial issue with it, keep cleaning the wire inside generator, the pipe above flames, if jet is blocked, which is blocked mostly by petrol, just open is, put WD40 in it, leave it in it and then clean it. Petrol gives problem in high altitude, Kerosene runs best in it.
@@danielmitchell5814 thank you brother for getting back to me, and for the advices, much appreciated 👍, I'll make sure I'll take good care of it for years to come,
@@just4all1 Most welcome bro
Use gasoline. For that you need number 33 nozzle.
Yuo do not let it preheat,. After spillimg some fuel, close the valve, light it and let it heat for 2 minutes, then open the valve and light it.
I found it on Aliexpress but a genuine Coleman is not that much more expensive. And you know the Coleman is gonna last 100 years
Itu pipa apa yang melintang diatas api?kenapa tidak lewat bawah...kalo kebakar terus terusan apa tidak beresiko bocor
The flame heats the tube to vaporize the fuel and pressurize the fuel tank.
Una pregunta cuantos dura este fuego prendido ? CUal es mejor BRS 12A o BRS 29A. ?
no probado, pero responderé una vez probaré
Cool
Which oils are you using to burn it up?? Simple kerosene oil can also be used in it or not???
simple kerosene is good.. I used "flammable liquid" which is supposed to fire woods fireplace.. "flamable liquid" is not OK..
@@prancishkus1194 thanks.. its mean i can use kerosene and it is good for it???? Thats right??
@@hassanmirza1199 Yes.
@@prancishkus1194 thanks
Not properly primed before opening valve
What about using diesel?
Diesel is a big no no. It's generator is not sufficient to vaporise diesel even after changing the jet.
Same question..ethnol??????
I have not tested it with ethanol yet.
Yes you can
@@prancishkus1194 Next video might need to show methanol and ethanol :)
Learn how to use your stove
that's what I was doing
Yellow flame is bad . You are doing it wrong . Try reading the instructions
Yes, of course, I wrote in comments that I am trying to use wrong fuel.
Ist schon blöd wenn man KEINE AHNUNG hat. Vorher mal schlau machen und dann los legen.
Ja richtig. Aber Leben ist Lernen.
저소음상향식 연소캡잇써요
펌핑이 부족함 30번 초반에해야됨
Rule numer one: never use it at home
Yes. Correct.
No good~~
You don’t know how to operate that thing