This is the best video to get this job done. I would like to add this tip. 1 remove the 10mm bolt on top of the heat shield for the rack and pinion and 2 while you have it out blow remove and clean your reservoir. Additionally blow your lines out to remove and dirt or debris. Excellent video sir and you have a new follower. Thank you
You guys did it all hard. Get the pulley off after its all unbolted with the pump pulley removal. While it’s in there. And put the pulley back on while it’s back in there but not bolted yet. That’s how I did it simple and faster.
Hello, hey I have a 2012 Chevy Traverse LT trying to put the power steering pump on and I'm having the trouble that when I drop the subframe on the passenger side it's only going down two of the four in required to pull the power steering pump. Can you think of anything I could have done wrong?
This is the best video to get this job done. I would like to add this tip. 1 remove the 10mm bolt on top of the heat shield for the rack and pinion and 2 while you have it out blow remove and clean your reservoir. Additionally blow your lines out to remove and dirt or debris. Excellent video sir and you have a new follower. Thank you
great video, helped me a bunch the way you came through the back versus having to drop the sub frame like the other videos, thanks
service manual calls for CAT removal, those guys dropping sub frame are not fallowing procedure, although im glad to see a way to not remove the CAT
You guys did it all hard. Get the pulley off after its all unbolted with the pump pulley removal. While it’s in there. And put the pulley back on while it’s back in there but not bolted yet. That’s how I did it simple and faster.
I just did same on my 2015 Traverse. Took longer to take the wheel and tie rod off.
Collie budz playing in the back, love this dude!!
Thank you sir, I am about to take on this same job your video was very helpful
The music in the background
earth a run red 😂🔥💯
Thanks you for your video it was very difficult 😁🤞🏁💨
Great content Brother Thanks
How long did it take for you to take it out this way?
I have an 09, and I think my is going out. It wines, and it's getting hard to turn the wheel. How much does this job cost?
Is this AWD?
Hello, hey I have a 2012 Chevy Traverse LT trying to put the power steering pump on and I'm having the trouble that when I drop the subframe on the passenger side it's only going down two of the four in required to pull the power steering pump. Can you think of anything I could have done wrong?
Well I didn't remove the subframe, you can see how I routed out, it little frustrating, but as I said patience is the key
Hi pressure flare nut is 16mm.
Oye hour job,removal AND instalación.
part# 20-2403
Im not a pro but i can do that job un half an hour.