Amazingly done mate!! Enjoy abit of screeding but this is on another level... im a time served resin floor layer but I can honestly say this finish is up there with the best I've ever seen!! Keep it up mate
I personally have done this method for many years and still do it, this is the mark of a true tile guy, if you can't do a large drypack job your not a top notch tile guy, this is further proof to all you guys on here pouring mud pans with way overly wet mud that it's wrong to do it that way, drypack is the only way. You should pay attention to this Mr Starr tile
Im guessing by your stupidity your a North American, this is a company from UK and this is all they do, they are not tilers!!!. And for the record this is ancient practice most clients prefer to pay a little extra for liquid screed ( Not mud). You guys are so far behind in construction its frightening. You build houses out of wood just to be blown away from a strong wind, bonkers
Most of the time i do this with another guy, we take it in turns as it is very physically demanding when doing large open areas. This guys a beast though
I can’t speak English very well. but this video makes me write comments. I know how fucking hard this job, I’m korean then I as well tiler. this work looks very good.
Great video...but for what it teaches, it could've been 30 seconds long...no info on how to maintain levels, what ratio to mix screed.... safety..ie corrosivness of cement and potential for chemical burns ect...
Cement to sharp sand 1:4 ratio and some polypropylene fiber if needed to reinforce the floor. Keep adding water until mix is held in the ball shape when squeezed by hand.
there are two ways to do it either with scaff tubes(timber etc) or make a bridge with screed side to side,,in this video he has made two beds of screed side to side(which are levelled) and his straight edge is sliding back n forth on it..then you just fill in the middle bit.
It needs to be damp/semi dry,so that it;s loose when being mixed,but if you put a pile on the ground,and tamper it down,you should be able to trowel it to a nice smooth surface,without it breaking up. It isn't easy to give a ratio for water,as sand is often damp or wet when bought. Sellers often say it's to stop it blowing around,but the truth is wet or damp sand is heavier than dry, so more money can be made per tonne.Even the stuff in poly bags is often soaking wet. Put a mix into the mixer,then add a little water.Take a shovelful out and try tampering it.If it breaks up,it's too dry,but don't over wet it,or it's useless.
A dying breed, this guy is a tradesman. Great work
Hard graft, and he's been taught by the best, well done fella.
Amazingly done mate!! Enjoy abit of screeding but this is on another level... im a time served resin floor layer but I can honestly say this finish is up there with the best I've ever seen!! Keep it up mate
I personally have done this method for many years and still do it, this is the mark of a true tile guy, if you can't do a large drypack job your not a top notch tile guy, this is further proof to all you guys on here pouring mud pans with way overly wet mud that it's wrong to do it that way, drypack is the only way. You should pay attention to this Mr Starr tile
@ Jason, lol. +you're right about Starr Tile... his mud is way too wet
Starr tile guy doesn't have a clue...
Jason Morgan ,haha I've seen mr Starr videos too , doesn't take much to make a pan fail huh (-:
Im guessing by your stupidity your a North American, this is a company from UK and this is all they do, they are not tilers!!!.
And for the record this is ancient practice most clients prefer to pay a little extra for liquid screed ( Not mud). You guys are so far behind in construction its frightening.
You build houses out of wood just to be blown away from a strong wind, bonkers
Glad to see he is wearing a reflective vest. Most people would overlook this step and then the concrete won't cure properly.
I keep telling the finishers that, they just laugh at me. LOL.
is outside the door a site?
Lol. Was wondering what that was about too!
LOL
Its screed not concrete
wow...beautiful job. i love watching professionals doing it the right way.
He's learning the trade well, at 27 years old I'd have that floor finished in about 3 hours , those days are over but boy they were fun (-:
highly skilled tradesman, very impressive, well done
This guy is a beast. A true talent right there
My dad screened all over London n d 60s n 70s n this lad knows his trade.
Screened????
@@smackflack5771sorry Sigmund Freud screened.
@@smackflack5771 sorry mate I'm an Irish illiterate.
Made that a lot more work than that ever should be. There are machines these days that help you know.
Most of the time i do this with another guy, we take it in turns as it is very physically demanding when doing large open areas. This guys a beast though
Been there done that,tuff work,you gotta be strong,nice job young man!
56 now- and got to do a floor screed like this, not looking forward to it lol
dread. 65 now missed the retirement have to work another year to receive pension .Have to do a floor screed tomorrow 😭😭😫
I can’t speak English very well. but this video makes me write comments. I know how fucking hard this job, I’m korean then I as well tiler. this work looks very good.
Make a channel
U are well understood
Even watching that my back hurt... You are one tough worker....
Strong as a bear ! Great work and making it look easy , and if your in the know it ain’t !
Très belle technique de travail ....je le fais de la même façon.... depuis des années.
Can you do a video of the dried screed and put the straight edge on at different angles , so we can see if there is and humps please.
Makes it look easy! How is the level kept?
When that ray stood still on the floor that means it's perfect level brother
Show de trabalho. Parabens. Gostei muito. Like👍
Americano gosta de inventar, por que o cara nao fez por partes no fibal do dia deve ta todo quebrado
With all that mortar down, you have to be quick. Tough job but someone's gonna do it. Good work!
J Rod gg Ja
He just filling in the middle see the two row of dry set on the two side that is level already so he do not have to check the middle link Bahamas
Maşallah, usta diye buna derim, helal olsun sana arkadaş.
나무 막대가 참 길군요. 정말 시원시원하게 일 잘 하십니다.
Nice job!! Mate!!
Skills pays the bill!🇺🇸🤓😉🤔
Within a few years of doing this job your back is f****d up.
So you guys specifically float floors for say tile and wood floor guys and that’s it, you don’t do the finish surface or is this a finished floor?
Proper job from a pro.You get what you pay for.
you are number one 👍💪
O trabalho deles são bem mais melhores do q aq no Brasil parabéns ótimo trabalho Deus abençoe 👍👏👏🤜🤛
Seu sabor
Hello. Which aggregate is used here? Aggregate particle size please. Thank you
The finish looks so smooth
Would guess a 3:1 sharp sand mixed just wet enough to clump.
Sharp washed sand 0-4mm grade- 70% grit/ 30% fine.
What is the mix ? I’m sick of uneven floors at work and trying to get over with deep base self levels
Someone needs to give credit to the fellow who mixed it for him. It's very important to have a consistently mixed dry-pack.
It's an art that many can't do ,
it looks very easy to me,bcoz I'm a hard worker and I know best easy and fastest tricks
Can u paint it when finished .or does it get pepple dashed
Gets tile pussy
Great video...but for what it teaches, it could've been 30 seconds long...no info on how to maintain levels, what ratio to mix screed.... safety..ie corrosivness of cement and potential for chemical burns ect...
No gym required that's one hell of a full body workout but kills the back a bit.
Fair play mate great job 💪
I want to know which knee pads he's using because I need a pair.
DodgeCity111 get proknees
Basically his knees are in soft sand....he doesnt even need them
Look in your wife's closet
Amazing exercise 😁
Never seen anyone on their knees screeding .ruff job if you ask me
How else is he going to do it ffs, float on a magic carpet . Thats the way its done . No more about a soup sandwich
I am going to do that in my grandparent's house tomorrow. I never did it before lol. But fuck it, if I mess it up, i have huge hammer
En qué momento le pone agua para que endurezca el concreto
Why not use self levelling compound? Cost maybe?
4” of that is ridiculous and this is a flatter floor.
What is the ratio of dry pack
Great work fella!
really master of his trade
May I have a question? How many inches thick to make a good sub-concrete floor? Thank you very much.
Great work. Kudos.
Is this a good trade to earn money?
Sir suppose Miti ki jameen sae laker tile tak final el video plz
good job. how many square meters can you do per day?
Parabéns pelo ótimo trabalho 👏👏👏👏
I enjoy that work!
bravo! I ll do that in the garden
NO BRASIL BAO MESMO É O DETRAN. IPVA. É O MAIS CARO DO MUNDO. PARABENS DETRAN
I want a job like this experience for 6 years
Cata apa trebuie sa pui in compozitie
Is this going over under floor heating
What do u think fool
please answer! where can i get those knee pads ??
Of the shelf.
Your wife got 2 pair 🤣🤣
일하는 모습이 진지해서 참보기줗네요
En my pais se le yama toping es el mismo proceseso aca en panama💯
Saludos exelente trvajo
My job too but very tiring
Im sure you dont have any certifikate for this material..
Fuck certificate
marasz165 yeah right build houses without quality control so better live on the street... what bull shit ... commmon ,,,!!!
Goed job respect from morocco
Nice Job, congratulation
very nice 👌👌 job Witch material i need for this??
Cement to sharp sand 1:4 ratio and some polypropylene fiber if needed to reinforce the floor. Keep adding water until mix is held in the ball shape when squeezed by hand.
Nice job
C est super propre
great job
감사합니다 ~♡
Hard worker....weldone
Makes it look easy. It is not.
I think it is good job done
Tom. To
not easy and be carefull for you knees
it actually is easy
Good work , sir
Deze vloer kan niet veel hebben, word alleen glad gestreken niet aangestampt.
optisch mooi eindresultaat maar heel zwak
Good job.
I know this tricks from past 12 years
No Brasil e difícil achar uma régua boa assim.....
E um q faça desse tipo.
Good job
Very good
Level?
Soy albañil y no entiendo cómo polvo de cemento se puede secar despues
Hard work
How does he know if the floor is level?
there are two ways to do it either with scaff tubes(timber etc) or make a bridge with screed side to side,,in this video he has made two beds of screed side to side(which are levelled) and his straight edge is sliding back n forth on it..then you just fill in the middle bit.
did he allow the side bridge to dry first before filling the middle?
Great Job Bro
Thank fuck im retired but i was a beast some views them wes 😅
Damn that looks physically hard.
Donald Thompson ,yes Sir after 30 yrs of doing this as a master tile setter I can honestly say my body is a train wreck (-:
VERY GOOOOOOOOD
thought the kettle was boiling for a minute there..
The guy who mixed up was in the pub
Hard worker.
Is it concrete ?
Semi dry sand/cement mixture,no aggregate.
what are the ratios?
Four sharp one cement,is the most usual mix.
manonamountain Thanks and what is the water ratio to achieve that dryish consistency of the sharp and cement mix
It needs to be damp/semi dry,so that it;s loose when being mixed,but if you put a pile on the ground,and tamper it down,you should be able to trowel it to a nice smooth surface,without it breaking up.
It isn't easy to give a ratio for water,as sand is often damp or wet when bought.
Sellers often say it's to stop it blowing around,but the truth is wet or damp sand is heavier than dry,
so more money can be made per tonne.Even the stuff in poly bags is often soaking wet.
Put a mix into the mixer,then add a little water.Take a shovelful out and try tampering it.If it
breaks up,it's too dry,but don't over wet it,or it's useless.
Screed is very dry although he is doing s great job it would be hard to keep that level of labour up week in week out
Ele é moto táxi ou pedreiro
Kkkkkkkkkk
Hard Yakka mate. I'd be there all day.
Get that barra oiled 😎
Proper grafter!
Отлично непонятно как уровень задает?
По сторонам было выведено две насыпи по уровню при помощи правила и обычного уровня и уже по ним все, что между.
Stan Owden Спасибо не увидел.
Ah ye al rite ! Yee be fine.