Fiberglass Layup Demonstration

In this video I demonstrate Fiberglass Hand Layup (Open Mold).
I'm using Epoxy Resin for the matrix, and fiberglass tape for the reinforcement.
The mold is aluminum shaped by an English wheel covered with wax paper.
#Fiberglass

[@oliviergorlier8135]

thanks a lot. Short simple and perfect

[@RDeanOdell]

Thanks so much!

[@stelamincomresinefiberglas8151]

شكرا على المعلومات القيمة

[@alphaecholima6897]

Goodluck sa XMAS guyss. Awph EXAM diay Hehehehe

[@dragoniteadvanture8971]

Can we use woven roving with epoxy?

[@RDeanOdell]

Hi,
Yes, you can use epoxy with woven roving. It is thicker and more dense that the fabric I use in the video, so it is more effort to wet out and uses more epoxy than than fabric. Chopped Strand Mat is the kind of fiberglass that typically does not work with epoxy.

[@bipedalhominid6815]

Expect to go through GALLON after GALLON if you use 24oz woven.

[@Akash_Murali]

Email id please

[@Alumni6042]

You should place your resin down first. Even when I've saturated the first layer of cloth, I've had pockets of air.

[@sethforbis1114]

Thats just bad method...the better way would b to have ur layout mold be solid, not a bent sheet...then after u lay down all the epoxy, u use stretch plastic to put HEAVY pressure on the cloth, so any air bubbles and excess epoxy get pushed out, epoxy is just glue, its the fiber doing the work, u want as little epoxy involved as possible!

[@jaywinters2483]

Tie your hands 🙌 so they don’t move so much.