That is so freak'n awesome... I have two angle grinders so i am going to make that modification to your design and i am also going to attach it to the side of my rolling bench grinder table... Again,, awesome piece of work
I love it, lots of good ideas, but just a small reminder: speed up yout video for example by cutting your pieces in one shot not all of them. The same with putting stuf together the first screw and I the last screw is enough for making your point. Anyway Thanks for sharing from Mexico.
Do this if the piece you’re cutting on the mitre saw is bigger than the blade when laying flat. Tip the board up to continue the cut. Going halfway through and then flipping the board over doesn’t always give you a continuous edge.
That's why Germans are there where they are, because only a German would be concerned about it 😅 It's true though they first look at the flaws and often don't even dare to admit a good result eventually. Just saying buddy.
Finally, someone that does the gluing without stopping to smear it around.
Next video show products before starting to build.
That is so freak'n awesome... I have two angle grinders so i am going to make that modification to your design and i am also going to attach it to the side of my rolling bench grinder table... Again,, awesome piece of work
Nice setup 👍👍
One addition to the bench grinder mount. A hook under the front edge of the bench for the chain so you don't need to fumble around to find it.
Nice, great ideas
I love it, lots of good ideas, but just a small reminder: speed up yout video for example by cutting your pieces in one shot not all of them. The same with putting stuf together the first screw and I the last screw is enough for making your point. Anyway Thanks for sharing from Mexico.
Good job!
Que legal, Parabens .
Astucieux
Мастеру респект за старания . Но я не пойму зачем так всё усложнять ?
Респект принимаю 🤝
А вот, если вы считаете это сложным, сделайте проще. Я ж никого не заставляю повторять 😄
Vid too long
Do this if the piece you’re cutting on the mitre saw is bigger than the blade when laying flat. Tip the board up to continue the cut. Going halfway through and then flipping the board over doesn’t always give you a continuous edge.
Tipping the board can be very dangerous. Not a good idea.
Имеет право на жизнь.
Please don't "Cut Shots", continue just the way you you are. Leaves out any guess work.
Click bait
Ganz schön viel Verschnitt! Besser wäre eine Kreissäge, lass die Stichsäge doch weg!
That's why Germans are there where they are, because only a German would be concerned about it 😅 It's true though they first look at the flaws and often don't even dare to admit a good result eventually. Just saying buddy.
😀👍👍👍👍