Great video, Art! The restoration series have been your best videos on your channel so far. Man, the leadpipe with the solder. Isn't there a chance that it will leak? I did that once at my shop and I was scolded for it!
Jep Fo same here! It wasn’t on a lead pipe but my mentor showed me how to deal with a similar issue by using a slide expander on a ferrule. Slightly expand one side only and it makes the transition between the two sizes of tubing a bit easier with way less solder. Not sure if that is “hoyle” or not but it worked!
Here is a link to a video that I made. It is from a video of me restoring an old cornet. There was a lot of solder that needed to be cleaned on it. ruclips.net/video/t14N-AmIkVA/видео.html
Watching your instrument Repair Videos truly are the highlight of my week Art! These are amazing videos and I really hope you keep it up,
Thanks for another interesting video. Enjoying the restoration process.
The tube that holds the bell onto the Valve section is basically your Tuning slide
Great video, Art! The restoration series have been your best videos on your channel so far. Man, the leadpipe with the solder. Isn't there a chance that it will leak? I did that once at my shop and I was scolded for it!
Jep Fo same here! It wasn’t on a lead pipe but my mentor showed me how to deal with a similar issue by using a slide expander on a ferrule. Slightly expand one side only and it makes the transition between the two sizes of tubing a bit easier with way less solder. Not sure if that is “hoyle” or not but it worked!
@@mr.schwall6144 Same here, I would have expanded the end of the leadpipe to have a better fit between tubings. I'm not fond of soft solder fills
That bell looks terrible. I can't wait until next week to see you doctor it up. I liked seeing how you made a trombone lyre into a collar.
So rather than make a collar you were able to recycle one from a Trombone Lyre (basically a music stand that attaches to the instrument).
10:18 Oh this was a good one
I’m a repairman in Chicago. Wanted to know about cleaning up excess solder around joints
Here is a link to a video that I made. It is from a video of me restoring an old cornet. There was a lot of solder that needed to be cleaned on it.
ruclips.net/video/t14N-AmIkVA/видео.html
11:39 Well alright, this will save us alot of time.
whats the mix ratio of the ammonia and water for neutralize the flux?? Thanks for another great video!!
10:41 Bonus Points