The connectors don't come off the PCB adapter plate as easily as you have shown in the video. One of the connectors broke when trying to replace the nozzle. So when I went about trying to remove the board, 2 other connectors broke. I have zero confidence that even the replacement board will be any good. That is in the event I actually get a replacement board in my hand. Net result I have a big printer from which I have not even printed once so far. This was my first elegoo purchase for my print farm, totally disappointed.
@elegoo how do I clear a jam deep in the extruder.
I second this!
Heat to 400°C and use a fine nozzle cleaning needle for some minutes up and down.
@@Muffnsausn максимум 300°C, и не помогло(
Do you have an issue with the board?
Where do I get the board???
Hello friend, please email to 3dp@elegoo.com and our staff will help you further.
The connectors don't come off the PCB adapter plate as easily as you have shown in the video. One of the connectors broke when trying to replace the nozzle. So when I went about trying to remove the board, 2 other connectors broke. I have zero confidence that even the replacement board will be any good. That is in the event I actually get a replacement board in my hand. Net result I have a big printer from which I have not even printed once so far. This was my first elegoo purchase for my print farm, totally disappointed.
Never remove a connector by pulling on the wires.