S2000 PCI Sliding Seat Rail Install - How Low Can It Go?

How low can you get the Recaro Pole Position seat in this PCI sliding seat rail? Just as low as the buddy club rails, however it does require some modification. This video is an in depth guide for how to install and modify the parts to get the seat on the floor.

[@HatchGill]

Love your attention to detail

[@minSUCCC]

Looking good!
I also notched the bracket by the rear holes to mount the seat lower, but after watching your vid, I'll probably modify it more to lower it even further haha

[@jiurriza]

Great video!! Thanks for posting it.

[@reidduff6985]

Great video!! Love the in depth review and modifications needed to make it suitable for you.
Very timely as I’ve been running my pole position on buddy club rails with hard dog for about 13 years now. I think this will be a great upgrade.
Any thoughts why you chose the slide version over the static mount?

[@NAUS2K]

When I autocross, I like to sit on top of the steering wheel more for better visibility of the course/cones. On track I need to slide all the way back for maximum leg room to be able to heel toe downshift. Hope this helps, thanks for the comment man!

[@LoveLikeaHurricane]

i'm considering getting Ballade sport Mugen seat rail with Pole position ABE

[@Darksilence130]

beautifully edited videos man. Thank you. With this setup, how much of a height seat drop compared to oem would you say you have? Also what rollbar is that in the back?

[@NAUS2K]

It’s about 3 inches lower than the stock seat. Huge difference. The rollbar is a harddog double diagonal , I have a full detailed install video on my channel on the rollbar, check out my ap1 playlist on my channel!

[@Darksilence130]

@@NAUS2K Thanks. Ill check it out.

[@soloryderrr]

So all in all would you recommend this to someone who already has the buddy club rail? It seems that it goes just as low, but the advantage is the build quality is better? Also, how much hammering did you do to the floor? I have my pole position setup with the finger gap under the back, I assume you only need 1/4" hammered down on the floor to make the seat work on the lower setting

[@NAUS2K]

If your buddy clubs start to have play develop like mine did I’d say yes go for the pci, the mods I made here were pretty minor all things considered. I just took a dead blow hammer the that hump a couple years back, I got it lower but wasn’t a huge change. Just enough

[@danielfoxr]

what about the passenger side

[@NAUS2K]

I run the stock passenger seat