Legend mate. had a Russian explain this in Russian to me and didn't understand a thing now I will finally get the flaming thing fixed. On a side note I appreciated your self control when you dropped your tool i often watch these videos with my children around and am always looking for clean channels. big thumbs up from me.
I need to do this to my KL Verada, does it matter what timing position you have the motor in before you start? Where did you get your valve spring compressor tool kit from? Cheers
“ Had” exact problem. But oil consumption has slowed significantly. How ever still puffing smoke when beginning of accelerating. So I’m going to replace the stem seals and hydraulic lifters while I’m at it. Ticking noise at cold start until warm.
Legend mate. had a Russian explain this in Russian to me and didn't understand a thing now I will finally get the flaming thing fixed.
On a side note I appreciated your self control when you dropped your tool i often watch these videos with my children around and am always looking for clean channels. big thumbs up from me.
I just done the valve stem seals on my KL Verada, your video was a big help thank you
1:00 - this can only understand those who are brave enough to make repair works on mitsubishi engines...
Great public service, very informative.
If you give the retainer a tap with a hammer it comes loose alot easier.
Good video 👍
Thanks for posting the vid! I’m working on a 1989 Montero, stem seals. Where did you get that great On-car valve spring tool?
Loved it, spanner fucks off and... DAMMIT
brilliant idea with the airline omg
Hi where did you get the tool from ? If you can share that it would be helpful, ty
Yes!! Cheers Rudi haha been scoping RUclips for ages then I found ya haha
Great video!
Does the MIVEC system on the 6G75 MIVEC make this any more difficult, or is it basically the same proceedure?
How much is compressor pressure, Mate?
Around 90psi
tank you to
I need to do this to my KL Verada, does it matter what timing position you have the motor in before you start? Where did you get your valve spring compressor tool kit from? Cheers
Your a fuckn legend mate
Aaaand done!!
Now repeat 23 more times😆
How much pressure is needed?
About 80 psi does the job
Thank you for the video! Was this a 6g74?
Yes 3.5l sohc 6g74
What the problem with valve seal
Get's old and leaks oil into the cylinder
I change valve seal in pajero blue smoke gone and I apply rope method
Thanks for share useful video
Hi brother , I have pajero 3.8 gls 2008 model, facing issue engine consuming engine oil every 1000 km run, do you have any solution for this ?
Try liquimoli valve stem seal rejuvenator or replace the stem seals.
Have exact car and has exact problem.
“ Had” exact problem.
But oil consumption has slowed significantly.
How ever still puffing smoke when beginning of accelerating. So I’m going to replace the stem seals and hydraulic lifters while I’m at it. Ticking noise at cold start until warm.