No you don’t have to, It’s already programmed to it, If you change the module then some cars may need to be programmed but the original doesn’t need to be programmed again
hi, can you tell me whether to replace Tout with the letters FF on the airbag computer to reinstall the crash. because my device does not erase automatically. THANKS
I try doing a Honda and Toyota module with renesas chip and I get the message “adapter disconnected ….cpu r5f51725 uart - work with adapter isp “ the rj48 cable is connected properly . I do pinout as shown in image. Short the points and remove resistor .
Hakko or weller is good. I use kester leaded solder .... I know it’s a year old comment and you already figured it out but just for anyone else wondering
You are the best mate . Best video thanks
After you reset the srs airbag module crash data. Do you have to program the airbag module to communicate to the vehicle? Thanks!
Super.Regards Adam Poland
Good video 🎉
Can I used the Godiac gt for this if so which line is the glan on this Godiac
Pin1
Do I need to use the adapter or straight connection?
Thank you so much
So yes it did not work with straight connection you must use the ISP adapter.
Hello! After resetting the srs airbag module. Do you have to program the airbag module to communicate to the vehicle or not? Thanks!
No you don’t have to, It’s already programmed to it, If you change the module then some cars may need to be programmed but the original doesn’t need to be programmed again
hello, can you reset the subaru outback 2020 srs module?
Yes
It's interesting video thanks Sir 👍
thank you
hi, can you tell me whether to replace Tout with the letters FF on the airbag computer to reinstall the crash. because my device does not erase automatically. THANKS
Hello. Can you give a link to this libraries you shown. I need for american subaru outback 2019
No but I can sell them to you for $500
Did you still teaching how to clear crash data?
Hey there, I can not find your learning course ?? Do you train online ?
I don’t have course but I can teach
I try doing a Honda and Toyota module with renesas chip and I get the message “adapter disconnected ….cpu r5f51725 uart - work with adapter isp “ the rj48 cable is connected properly . I do pinout as shown in image. Short the points and remove resistor .
What solder and soldering iron do you recommend?
Hakko or weller is good. I use kester leaded solder .... I know it’s a year old comment and you already figured it out but just for anyone else wondering
Where can I purchase the CPT programmer?
good my firnd
thank you
Can I buy this file from you?