@@esmokebaby If you just compute for essentials, I'd say I'm in about 300usd. But with added cost of experimenting, it's a bit more than that. Still a good route for me as the DD is like atleast 400usd used. Plus everytime there's an update to anything, a diy dd can also be updated. Like say a new effect or higher torque/efficiency. I was hoping this encoder would be good so I could shrink down my setup.
What's this for?
That's for the position sensor.
@@dencio1976 oh ok for what project lol
@@esmokebaby It's a DIY Direct Drive simulation steering wheel. You can check out the videos prior to this one.
@@dencio1976 oh yeah that's right. I remember now how much you invested in it already?
@@esmokebaby If you just compute for essentials, I'd say I'm in about 300usd. But with added cost of experimenting, it's a bit more than that. Still a good route for me as the DD is like atleast 400usd used. Plus everytime there's an update to anything, a diy dd can also be updated. Like say a new effect or higher torque/efficiency.
I was hoping this encoder would be good so I could shrink down my setup.