6) Create a New Project in Siemens Simotion and Configure Communication (with CC)

CNC Router Machine Training Videos with Siemens Simotion
It can be reached the manual below:
www.icloud.com...)
You can directly reach my posts by SUBSCRIBING my channel;
www.youtube.co...
For all questions and collaboration offers;
[e-mail]

[@mehmetsaitodunkran8594]

Çok Teşekkürler.Çok faydalı bir paylaşım.Emeğinize sağlık.
Tekrardan teşekkürler.

[@burakozalp]

Rica ederim.

[@Vibeland]

susbtitles are very understandable

[@abbadubenzwin5157]

Can you make tutorial video about how to configure and programming applications of sinamics s120 connect to cu320 version G with s7300 but there’s no have ability to access directly at device simotion drives ?!

[@EngOmar-kz9qv]

Dear Sir,
Creating to you from Iraq.
I made a project using simotion 425-2 DP/PN and i tried to test servo motor using (control panel command ) but i got a message : (Value has been rejected.
Parameter p3984[0) could not be set to this value .
The old value will take effect again.
Possible causes Parameter p3984 (0000] Task cannot be executed due to operating state)
Please how can i solve this problem because i didn't found parameter P3984 ?

[@abrarfsd]

Can you share this commissioning manual or its link?

[@jiimmino85]

It's possible work in simulation mode with simotion scout ? thank you

[@burakozalp]

It's possible with firmware 5.1 and later version. It's called "SIMOSIM". It could only be monitored SIMOTION in other words technology objects and programs. It could not be performed to observe Drive-Component. In my opinion, it is not enough to monitor or do kind of things like PLC's Simulation Mode. Thanks for your interest.

[@gilbertdevera3339]

Hi sir how including the HMI in Simotion

[@nasreddinkalay5817]

Burak bey bu pdf leri paylasabilir misiniz

[@burakozalp]

Videonun açıklama bölümünden ulaşabilirsiniz.