Analysis of iron

Problems with iron
Iron control of the heating coil is broken, and the damage can be destroyed (2). Electricity in the week iron route has been destroyed by Ohm meter test whether the parts shortages that confirms must remove a step-by-step.
First, remove the need to handle and remove the inner lid. Please see attached Screw them. Relocated equipment maker as it is inconsistent with This is impossible to describe accurately. Open all the heat
(Thermostat Switch) must be seen within a week. Similar destruction of the oven Danny and the same, only the damaged inner coil is easy to prepare.
Point (Contact) where ground can begin. Although no visible gap by corrosion due to some pungent probably escape any contact. Therefore, you can contact with Ohm meter to check whether. Identification of more than 5 Ohm must be closed if the rust off some pungent and carbon have been closed. The Contact Point area, and rubbed with a little glue weeks can create a good contact with support. Absolutely must be broken by a new exchange. If you no longer work with a button instead of wire rods will be used to make direct contact Looping sets. But then, as the wire direct to stand outside by the hand instead of the Auto-person turn the iron off for it. This means that people are trapped is not forgotten. Overheating could damage clothing. At the moment when the need to be concerned because it can be easily purchased.
Now, for domestic-made and imported from abroad, coils are easily purchased. Purchase of a new coil buy iron to speak by name. Just install all ready.
Electrical Student