How to read those negative/positive values? If Lenght is e.g. -1 does that mean that it's too close to the front of the car, or to the rear? Same question for the Height.
Hello, Measurements are 3 dimensional. Length measurements are referenced from the zero plane. Length is then measured forward and rearward from zero. Width is measured from the center of the vehicle and height is measured from the datum plane. Thank you,
Please contact your local distributor by searching in the "Find a Distributor" tab on the right side of our website. car-o-liner.com/ You can also see international listings here: car-o-liner.com/distributors/headquarters-subsidiaries-en-gb/
![Как устроены швейные машинки? [Veritasium]](http://i.ytimg.com/vi/FFW0GcMCgd0/mqdefault.jpg)
great system the only negative is you can only watch 1 point move while you are pulling.
How to read those negative/positive values? If Lenght is e.g. -1 does that mean that it's too close to the front of the car, or to the rear? Same question for the Height.
Hello,
Measurements are 3 dimensional. Length measurements are referenced from the zero plane. Length is then measured forward and rearward from zero. Width is measured from the center of the vehicle and height is measured from the datum plane.
Thank you,
how much does it cost this measurement? and car frame machine ?
Please contact your local distributor by searching in the "Find a Distributor" tab on the right side of our website. car-o-liner.com/
You can also see international listings here: car-o-liner.com/distributors/headquarters-subsidiaries-en-gb/
👍👌👍👌👍👌
👍
Must be nice to measure without any obstruction 😅 10/10 times you won't measure with a bare frame
Urag