How to Install Humminbird GPS with Heading Sensor
HTML-код
- Опубликовано: 12 сен 2024
- Tommy's Great Outdoors LLC
@tommysgreatoutdoors
Music by Austin & Jessica Davis
@austinjessicadavis6907
Humminbird AS GPS HS Precision GPS Receiver with Heading Sensor
amzn.to/46k9Mn7
Humminbird As Grp Precision GPS Antenna
amzn.to/3CQQ2Kf
humminbird.us....
Nice video. I would just make a couple of suggestions. Before drilling holes in the boat I would mount it down with tape and go run the boat to check for any interference caused by the outboard, etc. Todays outboards have large output chargers and can cause magnetic interference when running at speed. Same for the trolling motor if you are mounting the unit on the bow. Once you have checked that your location is ok, mount the puck with just one screw so you can rotate the unit to help dial it in. Once you are sure everything is correct, then install the second screw. Can save a lot of frustration, ask me how I know ;-)
Great video! I just install humminbird gps plus heading sensor. I can get my COG and my Heading to line up going in one direction but, I f I turn atound and head the opposite direction they are off about 20 degrees.
It’s possible you’re getting magnetic interference from your motor
Hey, Tommy. Is there a way to reach out to you for doing a product review?
Kindly FB messenger me at Tommy’s Great Outdoors.
facebook.com/groups/758302305263001/?ref=share_group_link
Did you pair your trolling motor to this new puck ?
No, there is a separate GPS puck that came with the MinnKota. However my Humminbird is networked to my MinnKota for features like follow the contour that will use this puck.
@@tommysgreatoutdoorscan you do I walk through on that setup. I’m trying to do the same
@@Dbig502 Yes! I have a Humminbird network series that I just finished recording. I should have it edited and released in the coming weeks.
Did you need to use the power line that’s coming out of the plug for the gps. It’s plugged and has the orange flag on it.
Only needed to plug it into the head unit. No other power was needed. Hope this helps.
@@tommysgreatoutdoors thanks and marry Xmas
What’s the pig tail 3 wires for?
If I remember correctly, it was for a NMMA connection.
Why do you want the device close to your transducer? You never explained.
Please watch at time 5:25 on the video. Hope this helps.