Thank you for sharing ! I'm exited to find out more about the Proma Myplasm products. ( looks like there out of stock right now ) Also very clean and precice build. Congratulation from Belgium.
Great video..I m putting together Proma Myplasm now..My old table just wasnt what it should be with cheap drivers and boards...cant wait to see it work..but this was one thing I was worried about..Make it clear...So ..how do yo like the Proma Myplasm by now any problems..software looks awesome....just problem getting setting right.
I’ll bet it really close... if you trace your leads you should be able to figure it out. Remember the material camp is the positive for the torch height controller. I can’t say for sure having only seen the inside my 900. It’s the only machine I have ever opened!
I wouldn’t recommend doing it though unless you have a good understanding of electronic/electrical systems. Electricity can be dangerous if you don’t know how to work with it, just saying...
I’m not sure I understand your question… the electronic controls are electrically isolated from the table and plasma and all shielded cables are grounded on one end only at the electronics box. Hope this helps
Thank you for sharing ! I'm exited to find out more about the Proma Myplasm products. ( looks like there out of stock right now )
Also very clean and precice build. Congratulation from Belgium.
Thanks for watching! It’s been a fun project and the Proma has worked really well with no issues.
Great video..I m putting together Proma Myplasm now..My old table just wasnt what it should be with cheap drivers and boards...cant wait to see it work..but this was one thing I was worried about..Make it clear...So ..how do yo like the Proma Myplasm by now any problems..software looks awesome....just problem getting setting right.
It’s been great, no problems at all. They seem to be really good about providing update versions...
Good video I have a hypertherm 800 do you think the wiring would be the same as the 900 thanks
I’ll bet it really close... if you trace your leads you should be able to figure it out. Remember the material camp is the positive for the torch height controller. I can’t say for sure having only seen the inside my 900. It’s the only machine I have ever opened!
I wouldn’t recommend doing it though unless you have a good understanding of electronic/electrical systems. Electricity can be dangerous if you don’t know how to work with it, just saying...
nice job man i'm glad you share
Thanks for your interest and nice comments!
hello for a plasma cutter 70a any 5v relay I can connect it to the interface
Could you be more specific? I don’t understand your question.
@@mrkrazyjeep a small 5v relay connected to arduino I can order stahlwerk cut 70
If your plasma cutter just requires a switch closure to initiate the cut then I would think any relay would work.
@@mrkrazyjeep it's very nice thank you
how to fix noise frecuency? thank you
I’m not sure I understand your question… the electronic controls are electrically isolated from the table and plasma and all shielded cables are grounded on one end only at the electronics box. Hope this helps
Thank you so much for the information .....
Sure thing, thanks for watching