thank you for your video i had problem with faul gauge and it as the sender like yours, today came my replacement. The new sender will "lock" in another angle so the metal inside the tank will not be aligned straight angle like before along to the tank, does it makes a difference or a problem? It would be aligned 30º counter clockwise . Old sender was easy to unscrew once i tried turning left just by hand , new sender apart that it locks a little bit more right (30º counter counter clockwise angle as i said) will also lock in position but not feels very tight lock. I cannot turn it more by hand, should i use some tool like long pliers to turn it a little bit more clockwise or once it feels locked by hand then i should not push it more? (i do not want to break anything) If i can turn it a little bit more clockwise then would also be aligned more correctly along with the tank.
@@clarencelove2638 A link to Ebay where you can snag one of these: www.ebay.com/itm/263584464459 If you expand the video description above it is revealed =)
![ATEEZ(에이티즈) - [GOLDEN HOUR : Part.2] Preview](http://i.ytimg.com/vi/X4PfgRPBUVo/mqdefault.jpg)
Where do you buy the espeicer for the hold
www.ebay.com/itm/263584464459
55$ and so worth it!
thanks so much for the link and video. I have a bad sender too and just bought the CNC part. Thanks!
Awesome, it makes it SO easy! Enjoy your bus adventures!
Yeah!!! Looking forward to the premere.
Should be fun! Metal work in shorts!
Nice job. I added a link card to my video :)
thank you for your video i had problem with faul gauge and it as the sender like yours, today came my replacement. The new sender will "lock" in another angle so the metal inside the tank will not be aligned straight angle like before along to the tank, does it makes a difference or a problem? It would be aligned 30º counter clockwise . Old sender was easy to unscrew once i tried turning left just by hand , new sender apart that it locks a little bit more right (30º counter counter clockwise angle as i said) will also lock in position but not feels very tight lock. I cannot turn it more by hand, should i use some tool like long pliers to turn it a little bit more clockwise or once it feels locked by hand then i should not push it more? (i do not want to break anything) If i can turn it a little bit more clockwise then would also be aligned more correctly along with the tank.
Hmm, is the gasket thinner than the original? May need to swap that if the rubber/cork is still good, that may be preventing it from fully locking.
@@bishopofrustyiron3101 Hi , i gave it some with a hammer and a flat screwdriver and now locks in a straight position!
gah man stuck in traffic again!
Question is "Where did you get the alum. plate?
Its from ebay, ill put the link in the description below.
@@bishopofrustyiron3101 where is the description for the plate located ?
@@clarencelove2638 A link to Ebay where you can snag one of these:
www.ebay.com/itm/263584464459
If you expand the video description above it is revealed =)
the grey panel is not the tank and thier is 2 inches or so from the floor to the top of tank.
Your right! Cool thanks!