Had a locked rotor code on one of these today but the compressor would start briefly and stay on but it sounded like it was losing its stage or variability
@@D2DNYAC yes it’s receiving high voltage and windings are in tact. It’s a digital compressor and I didn’t know it had that Loading and unloading feature until later. Luckily I didn’t give an official diagnosis until I got more information. I’ll go back later and adjust the set point or disable the valve but I think the compressor is fine after watching your videos. I’m a preferred member I can pm you with more info.
DUUUUDE I’m watching u more then Netflix stay BROOWN MY FOREIGN BROTHER
Thank you 🙏 😂
Ima sign up tonight bro definitely very THERAL descriptions on real life incidents…….
6:15 In beautiful Dixon, CA
You mean, "thorough"?@@roqueherrera8471
I’m about to work my way through all your videos! Thank you for posting these!!!
Great video are you working on a rack compressor or a chiller
Thanks
Cool! Haven’t seen these yet! 🇯🇲 thanks
Thanks for watching!
Mi Hermano I as a foreigner from MX u a bad ass
Thank you for stopping by
Some have a 3 wire thermistor set up. It's uses a PTC & NTC thermistors
Thanks for watching
Had a locked rotor code on one of these today but the compressor would start briefly and stay on but it sounded like it was losing its stage or variability
Is your compressor electrically sound?
@@D2DNYAC yes it’s receiving high voltage and windings are in tact. It’s a digital compressor and I didn’t know it had that Loading and unloading feature until later. Luckily I didn’t give an official diagnosis until I got more information. I’ll go back later and adjust the set point or disable the valve but I think the compressor is fine after watching your videos. I’m a preferred member I can pm you with more info.
I have a same copeland scroll compressor and it works and after dont pump but the motor is running.
May be i need to decrease the discharge pressure
No, my friend, just let it cool down completely by leaving it off, then see what you got!!!
What if xhange the compressor wirhout coresense protection module..it is possible? And how to wire or bypass the coresense?
Just shunt the switch wires m1 & m2
What are the factors to be seen when replacing a compressor if not getting same manufacture, let me know
Capacity, voltage /power supply, oil and you may have to do some additional piping and mounting
I hvav a problem of 4 flashing (scroll compressor high temperature) and compressor current is 120A
Could it be because of crankcase heater??
120 amps that sounds very high what's the supply voltage and compressor tonnage?
I just did a video on using my laptop to connect to the Coresense
Checking it out thanks
Hello👋. How named your multimeter?
I responded with a link to Amazon
@@D2DNYAC model, name, shield. Its wery saved me.
@@D2DNYAC i make very more audit and diagnostic works and simultaneously ampers and Volts its wery comfortable.
🤣Say the model.
You Will connect to this device. Bitzer standing analog only 95 series screw.
Thanks for watching
Sup my brotha
Yes sir