Man savage set up, all working good with the speed sensor? And how about the welds how are they folding up seen as the arms are cast? Looking do same on out road drift bus 👌💪
@@269Garage Thanks for the reply! Wasnt aware that you had to preheat cast, going to tack it with the flux core and take it to the local shop to weld it with the gas welder, been searching ages for a solution for the hydro so thanks!!
Not at the moment, we're pursuing a new shop currently. Been too busy to even upload archived videos lately, which I need to catch up on ASAP. Perhaps later in the future.
Man savage set up, all working good with the speed sensor? And how about the welds how are they folding up seen as the arms are cast?
Looking do same on out road drift bus 👌💪
Speed sensor works and the welds are holding fine thanks to welding all the way around and a proper pre heat cycle.
@@269Garage Thanks for the reply! Wasnt aware that you had to preheat cast, going to tack it with the flux core and take it to the local shop to weld it with the gas welder, been searching ages for a solution for the hydro so thanks!!
Also clean the heck out of it, no oils or rust.
Welcome back
Maybe I'll regain momentum
We produce LED for AUTO, Are you open to doing any product review? If yes, How can we connect with you
Not at the moment, we're pursuing a new shop currently. Been too busy to even upload archived videos lately, which I need to catch up on ASAP. Perhaps later in the future.