A quick qeustion, for finding damping ratio, why we need to input the dmaping ratio/alpha beta values....this means we are just getting the output as input,,,
Yes, It's a software. Whatever you see as a result is depends on input and type of physics you select and gets output. Garbage in garbage out this is how it works.
@@SysCADTechnoSolutions Let say I have three springs of different designs,, I used input ( damping ratios etc as same for all ), does the damping ratio i would be getting based on FRF of harmonic will be same for all designs ( becuase input is same ) or they will be different becuase of different geometries?
One quick qeury; I am comrpessing the spring and getting response in Y direction, does this means the participation factor table must be the "Y" to be considered by skiping all other 5 ( x, z, and rotations )
@@SysCADTechnoSolutions Sir this is with thermal condition only , I need to run steady state thermal analysis with temperature cht data first and then coupled it with static structural..Based on the temperature at the individual nodes , it should give us the creep strain..
Very good Information sir
Keep watching
Very good information.
Thanks 😊
Keep going one by one detailed conceptual
Sure 👍 We have added more videos. Kindly go through it. Share to your social profile and help us to grow. Thanks for your feedback.
A quick qeustion, for finding damping ratio, why we need to input the dmaping ratio/alpha beta values....this means we are just getting the output as input,,,
Yes, It's a software. Whatever you see as a result is depends on input and type of physics you select and gets output. Garbage in garbage out this is how it works.
@@SysCADTechnoSolutions Let say I have three springs of different designs,, I used input ( damping ratios etc as same for all ), does the damping ratio i would be getting based on FRF of harmonic will be same for all designs ( becuase input is same ) or they will be different becuase of different geometries?
One quick qeury; I am comrpessing the spring and getting response in Y direction, does this means the participation factor table must be the "Y" to be considered by skiping all other 5 ( x, z, and rotations )
Yes. Just check the participation factor in another direction it will be much lower compared to Y.
Sir how to do creep analysis using norton model with temperature cht data in ansys?
blogs.rand.com/randsim/2021/10/performing-a-creep-deformation-analysis-in-ansys-mechanical.html#:~:text=Ansys%20has%20the%20capability%20to,of%20the%20stress%20and%20temperature.
@@SysCADTechnoSolutions Sir this is with thermal condition only , I need to run steady state thermal analysis with temperature cht data first and then coupled it with static structural..Based on the temperature at the individual nodes , it should give us the creep strain..