ThankYou So so Much... I searched and watched many videos , but only I found your video helpful. I was needed to make a curved driven pattern and everyone was missing the important step that was composite curve... and then I found yours. thanks again.
I like the tutorial but I am having an issue. When i select curve driven model, and try to add the composite curve as a direction, I get an error “All segments of the profile must be tangential and they should be of one contour only”. I am using SolidWorks 2022. I tried to make sure I was using your tutorial. Any ideas?
Hello. Issue resolved. After doing some research, i ended up using a fit spline for my sketch since composite curve was being finnicky. Tutorial was a very helpful first step. Thanks!
Thanks a lot ! Just what i was looking for
Welcome
ThankYou So so Much... I searched and watched many videos , but only I found your video helpful. I was needed to make a curved driven pattern and everyone was missing the important step that was composite curve... and then I found yours. thanks again.
Thanks
A big THANKYOU to you! This is exactly what I need!
I like the tutorial but I am having an issue. When i select curve driven model, and try to add the composite curve as a direction, I get an error “All segments of the profile must be tangential and they should be of one contour only”. I am using SolidWorks 2022. I tried to make sure I was using your tutorial. Any ideas?
Hello. Issue resolved. After doing some research, i ended up using a fit spline for my sketch since composite curve was being finnicky. Tutorial was a very helpful first step. Thanks!
Works very well, thank you!
You're welcome!