This works best when the quad is at sag. The easiest way to to do this is un bolt the shocks and use a jack to set the quad at sag for example the yfz is 7-7.25” then you can make all your adjustments. Walsh race craft has a good in depth video on this for reference he has a sick setup he uses.
Yea this gets ya pretty damn close. It had a hard right pull and now it's dead straight. I seen a guy doing it jacked up in the air with wheels off the ground.. lol i was like thats not right 🤣
On your YFZ, how many degrees of castor do you have? I have different AARMS now. XC settings must be somewhat close to the MX settings? I just received a tool from four play atv. I found out about it from another RUclips channel. Gonna try front-end alignment on Sunday.
Awesome, thanks for the instruction!! I've been messing with it on and off for a couple of months getting by bars aligned but it wanted to wander left-right while at higher speeds. Hopefully this does the trick.
My 23 outlander was pulling to the right so I watched this video and found out the wheels were off. I corrected the issue it goes straight but when I turn it under steers. Should I set it back towards where they were?
This works best when the quad is at sag. The easiest way to to do this is un bolt the shocks and use a jack to set the quad at sag for example the yfz is 7-7.25” then you can make all your adjustments. Walsh race craft has a good in depth video on this for reference he has a sick setup he uses.
Yea this gets ya pretty damn close. It had a hard right pull and now it's dead straight. I seen a guy doing it jacked up in the air with wheels off the ground.. lol i was like thats not right 🤣
On your YFZ, how many degrees of castor do you have?
I have different AARMS now. XC settings must be somewhat close to the MX settings? I just received a tool from four play atv. I found out about it from another RUclips channel. Gonna try front-end alignment on Sunday.
Awesome, thanks for the instruction!! I've been messing with it on and off for a couple of months getting by bars aligned but it wanted to wander left-right while at higher speeds. Hopefully this does the trick.
@@johnschreier8150 Good luck! 🤘🏻
My 23 outlander was pulling to the right so I watched this video and found out the wheels were off. I corrected the issue it goes straight but when I turn it under steers. Should I set it back towards where they were?
@@willweinholtz1550 If it's straight you're good. You could have too much toe in. Double check.
“Set the toe and let her go”….
I'll drink to that 🍻