Does Variable speed and on \ off and other contols that came on the machine still work like a milling machine that you're making 3 phase to single ? I just want to make it from 3 to single without rewiring the whole machine
You wouldn't want to run them in series, you'd want to run them in parallel so they all receive the same voltage. That being said, if you ran 3 motors in parallel off the controller, all settings and all stops and starts would apply to all the motors. There would be no individual motor control.
Me to I like those drive a lot. I have the problem heavy load on the decent, error code. I need to install A big resistor on the vfd, but there no terminal for dynamic braking ( B1,B2 )?
Very helpful, thank you!
Does Variable speed and on \ off and other contols that came on the machine still work like a milling machine that you're making 3 phase to single ? I just want to make it from 3 to single without rewiring the whole machine
How do you wire it into analog 0-10vdc control???
Hi, why did I try to increase the speed or lower it when I tried to error? the VFD ty.
Question I can connect 3 motor in series on one of this controller??? Thanks you
You wouldn't want to run them in series, you'd want to run them in parallel so they all receive the same voltage. That being said, if you ran 3 motors in parallel off the controller, all settings and all stops and starts would apply to all the motors. There would be no individual motor control.
Me to I like those drive a lot. I have the problem heavy load on the decent, error code. I need to install A big resistor on the vfd, but there no terminal for dynamic braking ( B1,B2 )?
just found your videos, you would make a great teacher just readjust your camera for a better view.
B