The Tinyhawk freestyle 2, is the reason that I am seriously into soldering......and getting more proficient all the time! I have had a couple of these drones and they are so much fun! I recently accidentally throttled way up, when my drone was upside down over a parking lot(black top)! Just snapped my frame in a couple of places. Already learning how close the 3 motor wire pads are to each other. If you can successfully solder the 7000 kv motors without bridging joints, you are just about on your way to soldering anything. I recently ordered the lollipop vtx antenna, and the small plug which can be soldered in place. I think that I may just separate the wire inside and solder the lollipop directly to the board, connecting the antenna to the active element!
Its such a superb little quad! With loads of room for progression upgrading and learning!
The Tinyhawk freestyle 2, is the reason that I am seriously into soldering......and getting more proficient all the time! I have had a couple of these drones and they are so much fun! I recently accidentally throttled way up, when my drone was upside down over a parking lot(black top)! Just snapped my frame in a couple of places. Already learning how close the 3 motor wire pads are to each other. If you can successfully solder the 7000 kv motors without bridging joints, you are just about on your way to soldering anything. I recently ordered the lollipop vtx antenna, and the small plug which can be soldered in place. I think that I may just separate the wire inside and solder the lollipop directly to the board, connecting the antenna to the active element!