Rotork Electric Actuator IQ12 MK3|Assembly Disassembly|Hand wheel|Wormwheel&shaft |Battery|Drivebush

*Worm shaft maintenance kit, bearings, seals, O-rings, screws,
*Worm shaft thrust end cap bearing assembly
*Switch mechanism/encoder drive shaft, bush, clip, seal
*Complete gear case, center column, worm shaft & worm wheel, torque spring pack
* Hand/Auto Mechanism, lever, cam, spring, stop bolt, seal,
* Sliding clutch, coil spring, washer, O-ring
* Worm wheel & worm shaft including spring pack
Hand wheel Operation
A hand wheel Operation is provided to allow manual operation of the valve during electrical power interruption. During electric operation of the actuator, the hand wheel is mechanically disengaged from the drive. To engage hand wheel operation, the hand/auto selection lever is pushed down and released after which hand wheel operation remains selected. When electrical operations takes place the actuator will automatically return to motor drive without lever or hand wheel kickback
Battery Removal and installation
Remove the sealing plug using the appropriate Allen key, ensuring the “O” ring seal remains on the plug. Disconnect the battery wiring loom from the battery terminals. Using the black pull strap, lift the battery out of the rubber sealing pocket.
Fit the pull strap around the replacement battery and insert into the rubber sealing pocket. Reconnect the battery wiring loom to the battery terminals. Refit the battery sealing plug ensuring “O” ring is on good condition and correctly fitted. Hand tighten the sealing plug to 8Nm (6 lbsft) using appropriate Allen key.
Removal of drive bush
Using external circlip pliers, expand the circlip while pulling on the drive bush. The drive bush will detach from the actuator center column with the circlip retained in its groove
Install the base plate and tighten the four set screw securing the base plate to the grease case

[@maxfex5448]

hello i need more information and learn of the actuators rotork please i need your help SALUDOS DESDE VENEZUELA

[@reegadavis4263]

Super

[@huydoan1024]

Thanks you for your video. it's very helpful. I have issue with this MOV, 3 phase incoming power trip immediately when power up. then I checked resistance at power circuit L1-L2 is 250 Ohm, L2-L3 is 120 Ohm, L1-L3 is 0 Ohm. Please give some advice which part need to replace.

[@rajkumarrajkumar-lc3md]

Hi, IQ12 series MOV giving alarm on open and close fault. Kindly advise to resolve the problem. For your info. Its not operating from local but its operating from remotely(control room). when i change local to remote dispaly status are changing. Please advise to me resolve the problem.

[@Rotork-il6op]

Hi, I need to purchase a Rotork actuator

[@gazyoung8490]

👋👋

[@RAKESHSAHUable]

Please provide auma actuator details

[@abdomell1906]

عندي مشكل في مقود لايدور