MAXTON DESIGN - BMW M135i F40 rear valance assembly instruction

Video instruction showing how to install a rear valance to a BMW M135i F40
During the assembly of the valance there should be two people: one assembler and the other person pressing the valance to the bumper
The bolts and screws shown in the video are included in the mounting kit that comes with the valance
The tools shown in the video are recommended for this assembly
The film was made for instructional purposes
www.maxtondesign.com

[@Roy974]

Nice 👌🏽 really need more video like this !
I would like to see how to instal side skirt on a car like standard leon 5F , or standard golf 7 , who need to make holes directly on the metal of the car to install the skirt

[@Jim-jw8gb]

I used this guide to fit mine and it looks spot on.

[@georgiancalin8613]

How did you remove the rear bumper though?

[@matthewiles4701]

How did you remove the rear bumper ???

[@Jim-jw8gb]

@@matthewiles4701 3 screws on the inside of each the rear wheel arches, and a number of screws on the underside and it comes off. Takes about 20th so to get off.

[@jacobhess8572]

Question - Are the Diffusers & front splitters able to be removed without any physical damage left afterwards? (like screw/drill holes).
Thanks!

[@matthewiles4701]

Remove the back bumper - take out 3 screws (1 screw being a torx) underneath arches, then all screws off under rear diffuser, remove rear tail lights (remove plastic in the rear boot to remove the screws underneath), unclip the clips around rear bumper, fully remover bumper, fit new diffuser with self tappers ALSO make sure drill the original holes in the rear diffuser so this is secure as self tappers on there own with 2 nuts is not enough. Thank me later ;)

[@WinstrolVincent.]

😂 Ok

[@bsilversgreighley6689]

Nice video Pls more for renault or renault Megane RS Trophy ... thx

[@sebbivism]

Why aren't the outer screws delivered, painted black?

[@brianburns2335]

Do you do one for the new f44 grand coupe 2 series

[@yannick9076]

Does anyone here know if it’s possible to fit this v.1 diffuser with a tow bar?

[@marcinplich4069]

👍👍

[@FatihArmagan]

very amateur assembly work according to a manufacturer. Let me tell you just one mistake. Gloves are not suitable for the work being done.

[@baccara33]

Résultat final...il faut repeindre le PC qui a était de façon évidente et visible ,rayé par le carton . qui travail a meme le sol de nos jour.
Lamentable.