Draw full size in third angle projection a dimensioned front elevation and sectional end view of a 30 tooth spur gear, module 6, 20° pressure angle. Show three teeth on the front elevation drawn approximately and a table of gear data. The face width of the gear is 25 mm, rim diameter 158 mm, boss diameter 34 mm, reamed 24 mm diameter, boss length 50 mm. The boss is supported by four straight spokes of elliptical cross-section, the minor diameter being constant at 10mm and the major diameter tapering from 24 mm at the boss to 22 mm at the rim. Fillet radii 5 mm. The boss is symmetrical about the centre line in the end view. Show a revolved section of one spoke on the elevation Please help me with this it's an assignment
🎉🎉
Draw full size in third angle projection a dimensioned front
elevation and sectional end view of a 30 tooth spur gear,
module 6, 20° pressure angle. Show three teeth on the front
elevation drawn approximately and a table of gear data. The
face width of the gear is 25 mm, rim diameter 158 mm, boss
diameter 34 mm, reamed 24 mm diameter, boss length 50 mm.
The boss is supported by four straight spokes of elliptical
cross-section, the minor diameter being constant at 10mm and
the major diameter tapering from 24 mm at the boss to 22 mm
at the rim. Fillet radii 5 mm. The boss is symmetrical about the
centre line in the end view. Show a revolved section of one
spoke on the elevation
Please help me with this it's an assignment
Thank you so much.
You're welcome!
U are the best ❤❤
Thanks❤ I appreciate you.
@@alirule Sir....if only the pencil was darker 😢
Thanks more effort
You are welcome
Thank you but your camera is abit blur😢
you are welcome. Probably due to your internet connection or you download quality.
From 0⁰-120⁰ it's uniform velocity not acceleration
AFIT student...I see you sir 😅
😂 💔, it's well@@S_BoomTKD
yes unifprm velocity