Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
TQ sir
thank you, i really needed to see the auto set function, i always got it wrong because i could not wait and other videos usually cut this part of the video
Sir, I have problem when conduct auto set, error' code F1, I have removed CT bridge, but still error F1, is there any solution?
Muito obrigado, me ajudou bastante!
Very good
Show!
Sir what is the minimum ampere required to operate apfc in auto mode.And what is F-1 code
take load not less than30%
Yes SpenXor is right minimun 30% of Load current is required to Configure RVC in Auto Mode. Error F-1 stands for 'Current too small.'
Where are you...discription...?
This was taken at a very noisy site. We will upload a new video shortly with instructions! Thanks for the feedback
@@conceptelectionics7773 ok..thanks...
TQ sir
thank you, i really needed to see the auto set function, i always got it wrong because i could not wait and other videos usually cut this part of the video
Sir, I have problem when conduct auto set, error' code F1, I have removed CT bridge, but still error F1, is there any solution?
Muito obrigado, me ajudou bastante!
Very good
Show!
Sir what is the minimum ampere required to operate apfc in auto mode.
And what is F-1 code
take load not less than30%
Yes SpenXor is right minimun 30% of Load current is required to Configure RVC in Auto Mode. Error F-1 stands for 'Current too small.'
Where are you...discription...?
This was taken at a very noisy site. We will upload a new video shortly with instructions! Thanks for the feedback
@@conceptelectionics7773 ok..thanks...