Applies to Z10 as well. Consider cleaning the milk spout and soak in hot water for 10-15 minutes prior to ordering. Replacing the nozzle does not guarantee fixing milk sputtering
My Three Solutions, without replacing the nozzle. #1 ~ Only Lite/2% Fat Milk Only…..#2 ~ Shorter Milk Pipe…,#3 ~ Remove the Foamer Device, as noted here, I Boosted a piece of Split Silicone Tube behind the Milk Input, where the Milk Tube Inserts , the Cover will Go On With Ease, that worked for a Year. NOW, I am after all these, back to the Dreaded Sputter…!😢 Going to Soak the Foamer to possible remove build-ups.
Right off the bat, What is your problem there, Whole Milk is a Bad Thing for these Machines, high fat content really congeals/blocks the steamer, as it’s just too full of milk fat. Although this has cured my problems for years, and another solution I had, bolstering input with a piece of silicone tube, now it looks like yours there after all my “Tricks” prove unsuccessful….😢
What about hot milk, I have hsf several Z6 that makes fine foam, but have problem sputtering all over the place with hot milk....
It should not sputter whether you press hot milk or milk foam.
What about the z10? Mine is sputtering
Applies to Z10 as well. Consider cleaning the milk spout and soak in hot water for 10-15 minutes prior to ordering. Replacing the nozzle does not guarantee fixing milk sputtering
My Three Solutions, without replacing the nozzle. #1 ~ Only Lite/2% Fat Milk Only…..#2 ~ Shorter Milk Pipe…,#3 ~ Remove the Foamer Device, as noted here, I Boosted a piece of Split Silicone Tube behind the Milk Input, where the Milk Tube Inserts , the Cover will Go On With Ease, that worked for a Year. NOW, I am after all these, back to the Dreaded Sputter…!😢 Going to Soak the Foamer to possible remove build-ups.
Right off the bat, What is your problem there, Whole Milk is a Bad Thing for these Machines, high fat content really congeals/blocks the steamer, as it’s just too full of milk fat. Although this has cured my problems for years, and another solution I had, bolstering input with a piece of silicone tube, now it looks like yours there after all my “Tricks” prove unsuccessful….😢