The BEST Acura TL intake setup! | Bigger is Better...
HTML-код
- Опубликовано: 28 сен 2024
- Too complete a the full bolt on Acura tl type s! We have the J37 intake manifold with much bigger intake pipes!
HIT UP ON IG: taylor_tuned
for tuning and other bolt on needs!!
FBO SETUP:
PORTED J37 INTAKE MANIFOLD
3' AEM INTAKE
SMP PORTED LOWER RUNNERS
RV6 PCD'S
RV6 V3 J-PIPE
VIBRANT ULTRA QUIET RES
MAGNAFLOW REAR EXHAUST
FIC 775CC INJECTORS
LIGHTWEIGHTED CRANK PULLEY
TUNED WITH HONDATA
EGR DELETE
LIGHTWIEGHTED FLYWHEEL
HYBRID RACING SHORT SHIFTER
Finally I’m early for once lol. You should host a subscriber meet but give us a heads up because I’m in Washington but I’d make the drive over. I missed the last time you were here since I had to work unfortunately. But I’d be down to roll through. Keep up the good content 🤙🏽
Would definitely like to host another meet to show off the new look when it’s done 🙏🏽🙏🏽
I put the 37 manifold on my 3.2 04' manual tl and the throttle response is fucking nuts. Paired with a true CAI You can absolutely feel a power bump at the low end.
Just brought a 37 motor and gonna swap over the Crank, Rods, J37 Heads and cams + bigger fuel injectors. With a hondata tune I can get vtec to kick in a much lower rpm. Man I can't wait, plus now there'll be a detailed turbo guide if I choose to go that route.
Just tuned and test drove today, no lie response is 100% there can’t wait to drop the vid !
Did u get any vacuum leak codes doing the swap?
What’s the link to those rags bro!?! Gonna get em NOW 😂
Walmart!! lol I’ll go find a link and update description
LS3 sand rail huh, dope. My brother and I just started are sand rail we are thinking LS1 or LQ4
Aye sweet! Very few people out here for the rails! Maybe someday I’ll build a j series one
where can i get a cold intake tube like the one you have? been trying to get one for a while . nice setup by the way.
Heeltoe carries them
Ebay
🔥
I ran my cold air intake the same way but added stainless headers and got a big improvement. The cast factory manifolds really choke up the engine by alot.
J37 manifold isn't great for boost. Stock manifold holds up better. The material of the J37 makes it weaker.
I need that cupler you have that fits the J37 manifold so I can put my Weapon R intake back on from my J32
You can run j32 block with the j37 intake manifold ??
@@WOTRoyalJ I have the J37 manifold and 80 throttle body. The original cupler from my j32 weapon r intake won't fit
🔥🔥🔥🔥🔥
Those tires look like they run on top of water 9:11
Sand dunes brother, possibly water too with good speed lol
What paint product did you use to paint the tower strap bar cause I’ve been thinking of painting my red
Anything will work, just give it a good sand down prep.
@@TheLifeStyle6 thx bro much appreciated