The boards you plan to cut go on the top surface of the workbench. You can adjust the clamps on the workbench to hold the boards securely in place while you cut them. It might take a little getting used to, but once you see how the clamps work, it should make more sense. :)
![Путин и ПЕСКОВ ждут звонка от ТРАМПА 😁 [Пародия]](/img/1.gif)
Did you figure out how to use this? I’m confused about where the boards you plan to cut go
The boards you plan to cut go on the top surface of the workbench. You can adjust the clamps on the workbench to hold the boards securely in place while you cut them. It might take a little getting used to, but once you see how the clamps work, it should make more sense. :)