I tried that, the supports were basically still the same because of the lips of over hangs on both rims. Even when gluing it together, it was taking more time than just peeling the supports off. Good tip though!
You need some sliceworx plates (or similar plates). Leave the bed adhesives in the past. As the great Dominic Toretto once said, I’ll die before I go back.
I'd like to see the settings you are using for the pets in the supports.
I would print that snaredrums holder in 2 pieces and glue then together honestly. No support needed but just the bottom.
I tried that, the supports were basically still the same because of the lips of over hangs on both rims. Even when gluing it together, it was taking more time than just peeling the supports off. Good tip though!
That’s exactly what I was going to say just do a subtraction from the columns into the top ring
where did you get that a1mini ams lite mount?
You need some sliceworx plates (or similar plates). Leave the bed adhesives in the past. As the great Dominic Toretto once said, I’ll die before I go back.
Can you put links to the tools you use.
Hi Ryan, Where do you get that corrugated packing paper?
I buy it on Amazon!