Hi, I'm experiencing some issue with zeroing/alignement with my dlc burr. Once i zero it and grind something coarser around 60-70, then I can't get it back to finer. After that grind, new zero is becoming around 50 and hearing noises. Have you experienced something like that?
not sure, I doubt its the grinder or alignment. 99% of the time when I hear this its puck prep. Have received returned grinders that were "inconsistent" and I can pull 10 shots back to back and all the same. Might do WDT. if you are using something like a lever machine, that adds even more complexities.
Incredible alignment.
Thank you for doing this! Can’t wait for the MP
Been playing with the MP a little bit. It’s nice for sure. I need some different beans for it though.
Was watching with captions on, it says “ that’s the best Hawaiian burger I’ve seen” when you said best aligned burrs I’ve seen 🤣
Hilarious!
I just watched the whole video just for that. Didnt dissapoint. Lol
@@JoseRodriguez-wg9ei it needed a cut to Jules eating a burger in Pulp Fiction 😆
Does Dlc burrs grind for espresso?
Both dlc and stock espresso burrs technically the same but the dlc has a coating on them to reduce friction
Hi, I'm experiencing some issue with zeroing/alignement with my dlc burr. Once i zero it and grind something coarser around 60-70, then I can't get it back to finer. After that grind, new zero is becoming around 50 and hearing noises. Have you experienced something like that?
Unfortunately not really sure what is going on
My DF64V is inconsistent. Eg. with everything equal, one shot can take 35 secs, and another 25 secs. Could it be my burrs are not aligned?
not sure, I doubt its the grinder or alignment. 99% of the time when I hear this its puck prep. Have received returned grinders that were "inconsistent" and I can pull 10 shots back to back and all the same. Might do WDT. if you are using something like a lever machine, that adds even more complexities.
Nice video, would you happen to be doing a burr alignment for the DF83? Is it the same as the DF64?
Thanks for the videos!
Same, BUT I have a video. Think it’s on the 64 but is much more detailed. Check out my channel.
Just curious, how you clean the grinder after completing the alignment? Won’t the marker be poisonous?
Marker is not poisonous. Quick cleaning brush and run a few beans through. Good to go