MasterCam: Simple First Operation with Stock Setup, Facemill, Contour, and Chamfer Mill

[@bodbn]

This is a great intro video. Very good explanations of everything.

[@artofthepart]

Thanks so much for watching, glad you enjoyed it!

[@Cmtb125]

Please keep making videos !

[@artofthepart]

Will do, just posted two more today! Had to take a little break when the semester started.

[@habimanaandre3358]

Can You share with us the 2D Drawing of the model you are programming

[@khachik25]

Thank you so much for great videos. I'm using MasterCam learning edition and having problem with Rigid tapping tapping in verify. in backplot everything is correct but when i use verify it shows Rigid tapping as if its pecking to the final z, instead of one move. any idea why ?

[@artofthepart]

Hmmm, I'm not actually sure on that one. I don't do a lot of rigid tapping on my end. We usually use thread mills in class, but I can look into it!

[@artofthepart]

You may want to check your Simulation Settings. There's an icon next to verify and you can also check in your configuration from the File tab.

[@ipadize]

12:50 in mc2021 this used to automatically switch to the active wcs, now in 2024 (we upgraded from 2021 to 2024) it doesnt anymore. Do you know if there is a special setting in mastercam to change this behaviour or could this be a bug/feature?

[@artofthepart]

We just deployed MC2024 last week at school. I'm going to be looking into the new changes later this week. I'll keep an eye out for it.

[@artofthepart]

I have heard rumors that sometime when one feature is turner off/on it could be as simple as the software programmer accidentally deselecting that feature when bundling the new release 😅

[@ipadize]

@@artofthepart lol, i might make a post about it in the mastercam forum