Enjoy your videos.. I was cutting a strip of wood 12in w x 4in h and I probed XYZ.. when I hit start router started process approx 6in to the left. Would you have any ideas?
A complete guide should show zeroing out from both the work surface and the machine bed. I watched the whole video and I don't think you covered that. You talked about it very briefly but did not show it.
![Quando Rondo - Grow Up [Official Music Video]](http://i.ytimg.com/vi/8zFnCg3BO4Q/mqdefault.jpg)
You took the time to actually explain the reasoning and theory behind it. That helped me navigate the probe better.
Dude. Thank you. This is the most comprehensive look at the Probe that i have seen. very helpful.
Thanks so much! Your explanation and demo of the actual distances being measured really helped me understand. I appreciate this.
Wow! Thank you so much for explaining this so clearly and thoroughly! Your video should be added to Onefinity’s official guide. It’s so good.
Very beneficial for the beginner. Thanks very much.
Thanks for another great video. Will be ordering you dust boot asap. Look forward to your next video.
Just what I needed.
Can you orient the piece diagonally? To cut something longer than 32"
you have to fine tune the tolerances and put that data into the control for best accuracy but they are close be default settings
Enjoy your videos.. I was cutting a strip of wood 12in w x 4in h and I probed XYZ.. when I hit start router started process approx 6in to the left. Would you have any ideas?
Thankyou very helpful
A complete guide should show zeroing out from both the work surface and the machine bed. I watched the whole video and I don't think you covered that. You talked about it very briefly but did not show it.