Eaton Front Inlet TVS Supercharger Needle Bearing Installation LSA LS9 LT4

[@estetvelikolepniy9619]

Hello! Can you tell me how to restore the coating on the rotors? Thanks!

[@nasty_v5952]

Just watched the last video haha thanks !

[@tjwrongwaymead8374]

I feel like I should ad some grease to these bearings. What came in them is enough ?

[@qualitysuperchargers]

Eaton recommends you do not add grease to the bearings. You could end up pushing the seal out when assembling. The bearings come greased and ready to run.

[@nasty_v5952]

Helpful video but I have a question, how was the drive hub taken off ?

[@qualitysuperchargers]

www.ebay.com/itm/112920410395
How to Video
ruclips.net/video/BF9o6L_qd9E/видео.html

[@WickPerformance]

What brand sealant do you prefer?

[@sseilmnop]

I mostly use Permatex

[@sean.g4516]

No sound??

[@danwalters5230]

Can you replace the back bearings or do you have to replace the rotor pack

[@qualitysuperchargers]

We do not replace rotor pack bearing. We don’t recommend it, they are not made for disassemble and reassemble.

[@kennethreed5676]

Is it .055" below flush on the lsa 1.9 also?

[@qualitysuperchargers]

Yes 0.055” below flush for all the needle bearing’s.

[@kennethreed5676]

​@qualitysuperchargers thank you for your reply and thank you for the videos! I appreciate it.

[@witdaMacksauce]

Any methods on how to press in the needle bearings in m90 gen 5 if you don't have a press. Like what other tool could I use?

[@qualitysuperchargers]

You really should use a press!