burnt plastic I would guess you ran it dry? if its burnt plastic and you did not run it dry I personally would have sent it back for a different one. if its just a plastic taste just run it through the taste and smell should pass after a while.
I have the same problem, it seems the pump regulates itself automatically which doesn't work with my low pressure pipes so I've just been switching in on and off as needed manually
I just installed my pump but it is showing red light "failure" help me please AUTOMATIC PUMP CONTROL (10BAR) Voltage: 220-240V~50/60Hz Max current: 10A Starting pressure: 1.5bar Max pressure: 10bar Pipe diameter: 1″ x 1″ Protection degree: IP65 PERIPHERAL WATER PUMP Voltage: 220-240V~50/60Hz Input power: 550W (0.75HP) Max head: 45M Max flow: 45L/min Max suction: 8M Pipe diameter: 1″ x 1″ Copper wire motor Brass impeller 0.15m length cable
It's really hard for me to guess the exact fault without bveing there. you'll need to look for the problem. Start at the most obvious like and then move towards the more complicated faults. Here is a link that might help: www.iwaterpump.com.my/index.php?route=information/information&information_id=11
The pump works perfectly, watering the veggies and having a decent shower will now be easier and better!
Does it still work
@riyaazanthony2677 yes, it does still work.
Prices have increased substantially!!
i have purchased 3 INGCO pump control unit and the water tastes and smells like burnt plastic. How do we solve this?
burnt plastic I would guess you ran it dry?
if its burnt plastic and you did not run it dry I personally would have sent it back for a different one.
if its just a plastic taste just run it through the taste and smell should pass after a while.
Like it!insane !see u arund.
are ingco tools made in China?
where's the installation video
Sorry Bru, lost my hard drive due to eskom. footage was lost, was pretty easy though.
can we adjust pressure on/off?
I have the same problem, it seems the pump regulates itself automatically which doesn't work with my low pressure pipes so I've just been switching in on and off as needed manually
Hoe het die pomp toe gewerk? Sien nou daai maak orals. Sal goed wees om te sien hoe als werk. Groete
Ekt eers besig geraak met heinings opsit so ongelukkig nog nie by dit uitgekom nie, ek sal n video van dit ook oplaai!
Hy werk baie nice!
I just installed my pump but it is showing red light "failure" help me please
AUTOMATIC PUMP CONTROL (10BAR)
Voltage: 220-240V~50/60Hz
Max current: 10A
Starting pressure: 1.5bar
Max pressure: 10bar
Pipe diameter: 1″ x 1″
Protection degree: IP65
PERIPHERAL WATER PUMP
Voltage: 220-240V~50/60Hz
Input power: 550W (0.75HP)
Max head: 45M
Max flow: 45L/min
Max suction: 8M
Pipe diameter: 1″ x 1″
Copper wire motor
Brass impeller
0.15m length cable
It's really hard for me to guess the exact fault without bveing there. you'll need to look for the problem. Start at the most obvious like and then move towards the more complicated faults.
Here is a link that might help: www.iwaterpump.com.my/index.php?route=information/information&information_id=11
Is this true ?
Joined United States
👊 P-R-O-M-O-S-M.
00000000000
Bad reviews 🥴🥴🥴
oh no, thats not good to hear. I hope it works well enough for me.. I'll review it after ive used it. :)