No way that board was working. They neglect to tell you to install a jumper wire underneath D1 in order to get the power to the switch. In addition, there is no amplification, only preamp.
stop doing anything this circuit is a preamplifier it is totally impossible to drive a speaker directly with a circuit like this I have the same one and it doesn't work it's impossible
I'm liking the Old School touch, sounds great
Superb ❤
Excellent travail réussi.
SUPER
❤
Very nice sound ❤
The vacuum tube subwoofer is one of the finest circuits that produces clear sound
@@inventorkr1 it's a combination of old and new components = best sounds👏👏✌️
hi dear, is there possible to preamplifier a dynamic mic ou a guitar adapting a plug or respective cable? if yes, can wee add tube distortion?
C3, C7 2:50 NOK, 3:12 OK. Did you install only one PCB?
How to remove the noise from speaker when not playing
It support 4 5watts mini speakers?
supports
👍👍👍👍
really want to make it but cant find gerber file on your blog for it
these are readymade kits from ali.
😄👍
Alea sunt leduri lămpile se aprind încet
Лампы в этой "схеме" просто для красоты. Очередной рекламный ролик. Расходимся.
👍👋👋👏👍
No way that board was working. They neglect to tell you to install a jumper wire underneath D1 in order to get the power to the switch. In addition, there is no amplification, only preamp.
wait.. are there LEDs in those tubes?!
Below yes
Satisfait?
Les résistances?
stop doing anything this circuit is a preamplifier it is totally impossible to drive a speaker directly with a circuit like this I have the same one and it doesn't work it's impossible
You can use this thing for active speakers
you can try with a high ohm, and high sensitive speaker. it will do sounds.
Cool little amp, but there's NO diy guide here at all.
منتاژ تنها ارزشمند نیست، اگر میتوانید آموزش کامل بگذارید
Опять не понятно какие радиодетали нужны для сборки 😮😮😮
RCA 😂