- Видео 16
- Просмотров 300 251
Mini Shorts
Добавлен 12 дек 2017
All the silly bits no one shows you!
Sealey VS820 stop leaking / retain vacuum
how make your brake bleeder retain vacuum. When you buy it add silicon lubricant to the 2 gaskets. It will make it seal vey well.
See my other video to see it in use on the car.
See my other video to see it in use on the car.
Просмотров: 2 198
Видео
Mini Cooper spark burn duration coil replacement
Просмотров 1753 года назад
Misfire on acceleration. Using BimmerLink can see the spark burn duration for each cylinder. Cylinder 4 had low millisecond duration compared with others. Changed coil. Problem fixed, misfire gone. No more error codes. The error codes associated with this problem were as below. All cured with new coil. 2EFE: 0x2EFE combustion misfire, multiple cylinders: detected 2F01: 0x2F01 combustion misfire...
Mini Cooper Rapid Flash alarm
Просмотров 9 тыс.3 года назад
If the alarm indication flashes fast when you initially lock the car, and the interior light is on, even though the car is locked - one of the doors is not shut properly. It should only flash (pulse) relatively slowly even from the first moment it is locked. On an R55 (clubman) it can be the side door that isn’t latched.
Mini Cooper brake warning wires error service
Просмотров 3,5 тыс.3 года назад
How to join to stop error messages. You need to do 2 things with a code reader after joining the wires. Clear the fault code (5E5D for worn rear brake pads, this may show up as a problem under dynamic stability control so don’t panic MK60 E5) and also then reset the brake service level back to 100%. Eg pay for the excellent bimmercode app for this and all other error codes etc. You may also hav...
Mini Cooper Gen 2 headlamp clips
Просмотров 523 года назад
Mini Gen 2 headlamp clips replacement. There are 2 of these for each headlamp.
Mini Cooper Panoramic sunroof Stuck - fix
Просмотров 62 тыс.6 лет назад
In very hot weather / direct sunshine it can lead to the sunroof not closing. It attempts to close, thinks there is an obstruction & so reverses. Very inconvenient. If you push down firmly on the centre of the glass as it closes, it will overcome the problem and allow it to close.
Mini R56 headlamp switch operation
Просмотров 29 тыс.6 лет назад
How to turn your headlights on using the indicator stalk controls.
Mini Cooper R56 squeaking window regulator fix
Просмотров 33 тыс.6 лет назад
How to fix. First the entire assembly must be removed from the door, which takes quite a long time. See pelican parts website for pics and procedure of that.
Mini panoramic roof drain holes
Просмотров 14 тыс.7 лет назад
Th water from the front can run along to the rear of the cills depending on the angle the car is parked at.
Mini lights on with unlock
Просмотров 9027 лет назад
Only if you have autolights option. If the auto light knob is left in the On position, the lights will come on as shown with unlock.
Mini R56 Heated Front Screen operation
Просмотров 17 тыс.7 лет назад
Mini R56 Heated Front Screen operation
Awesome. This also helped with my R53 making the exact same noise. Fix was exactly the same too. Only difference being the regulator is inside the door rather than on the door card. There is enough room to reach in and grease it all up though.
Do the front fog lights go on to when putting lights on? I have a 2010 mini cooper s 184 chilli pack. Don't seem how to turn off
Why this dont work on my mini r56? The error is still there?
Mini cooper fuel cap lever
That's the video I was looking for. Same horrible NOISE. Greasing the middle of the black rail through the speaker opening solved it instantly. Thanks 👌
Great tip, thanks. I also hit the wind deflector with some WD-40 w/ teflon, and put some silicone oil on the tracks, closes by itself now again. must have had some sand in the tracks. Cheers
Many thanks for this tip! It really helped me!
THANJ YOUUU
Life saving tip! Thanks!!
how do you have one touch closing? mine only one touch opens....
Should be no need for this faff on a brand new piece of kit....
I’ve problem with main pump cap / just goes a round and round
Thank you ! Thank you! Thank you!!! Worked perfectly
Thank you, I could not figure out the cargo nets for the life of me. I was so confused about the one that goes on the floor bc why would you add a net on a floor but to keep things down makes sense
I have a brand new one do I need to do this ? I don’t have the wrench tool ? I tried using my VS820 for the first time today but it was useless, wouldn’t hold any pressure at all ? It stayed at zero psi and would not pressurise at all ? What’s could be the issue.
Same here. Im googling like mad for a fix......failing that i might send the damn thing back
I did it from new before I used it. So then it worked ok