Видео

Very cool! I work for a boom inspection and repair company. We pride ourselves as the best at what we do as well! Keep up the good work. Would love to start working with companies who run concord

The easiest way I have seen to do this, is to turn the receiver off, then press and hold the power button on the transmitter. Turn on the receiver. Then after you hear a single beep from the transmitter, release the power button and watch the screen on the receiver. It should cycle through the words Po, then id. Once that is finished the transmitter will power off and the receiver will go into standby. Turn the transmitter back on and you should see a 1- on the receiver screen, signifying a tethered paired connection.

Good looking pump ! Ours has been great!

superrr.....

Thanks. What happens if you press the valves for pump forwards the wrong way around? You say driver side first but I would probably forget

40Z is such a great pump size. By far the busiest pump category in our fleet. Nice job guys 👍🏼👍🏼👍🏼

🔥🔥🔥🔥🔥🔥🔥 @concordpumps Thanks for the opportunity..

Good video ❤ keep posting helpfull tips

Very informative video guys. We’re very happy with the blast and paint which Concord recently did on an older trailer pump of ours 👍🏼👍🏼👍🏼

How to contact you brother,I have more questions about concrete pump.thank you

Wow, thank you brother for sharing

What's with all the distracting music?

Nice

buen bideo compita

Good❤

a tutorial on how to replace the plate and ring Tnks

Nice tutorial Boss Keep sharing Thanks

Grettings. Im working in a concord 2007 40 mts. And while im pumping happens like if an E stop is pushed but al they are working great, and i need to able from my remote every couple minutes, and work continuosly sometimes few minutes or maybe half hour and happen again and again. What colud be happening on your opinion?

sir. . . can u teach me how to retract a piston for changing of cup. . . please vlog it manualy on control panel. . . thank you

hehehehehe, very easy work in an ideal world: -the screws need, many times, a long bar for make more strenght, because there are many water, concrete, lock tite and oxide in the screws. -to take out the cup, woww!!!!!!, just with a small bar ? 99% times we need chains and hydraulic power, -to insert the cup, woww!!!!!!, I do not know if the cup measures 230 mm and the cylinder 300 mm, or the neoprene of the cup has a hardness lower than 81 degrees, I saw it enter very easily, all the time we need hydraulic force to insert them. -Regards....