Pressure A is always higher than pressure B on a 50% tensioning configuration, the % may vary depending on the LTF and the CLF. the Load transfer factor is calculated as: LTF=1.01+(nominal diameter/grip length). the Cross Load Factor commonly ranges from 1.15 to 1.25 so Pressure A can be calculated as Pressure B x 1.25. Pressure B already considers the LTF. Pressure B is residual load x LTF. hopefully this helps!
we were testing a piece of piping including some sort of a heat exchanger... there must have been hellova lot of air in the system. We tried to get all the air out but in the end, we pumped a pump just like the one in the video for over an hour non stop. I mean we filled it up at least 20 times.. and we only got up to 6bar. It was ridiculous. But it had to do because we had no time nor means to do anything about it.
YES!!!!!
This is not healthy.
Why?
عالی من یک استا کار سندبلاست از ایران هستم چند ساله تلاش میکنم این شغل راه اندازی کنم نمیتوانم بوجه کافی ندارم براش
What a relaxing video! We are a sandblasting media supplier from China. If you are interested please feel free to contact me.
I am interested
How much % is diference between Pressure A and B?Sample presure A 650 bar,how much will be B pressure
Pressure A is always higher than pressure B on a 50% tensioning configuration, the % may vary depending on the LTF and the CLF. the Load transfer factor is calculated as: LTF=1.01+(nominal diameter/grip length). the Cross Load Factor commonly ranges from 1.15 to 1.25 so Pressure A can be calculated as Pressure B x 1.25. Pressure B already considers the LTF. Pressure B is residual load x LTF. hopefully this helps!
Third class manifold
Ekdam ghochu technician very slow TRITORC IS 10 TIME FASTER THAN HYDRATIGHT
Good ol baker pump, remember, the first hundred is the hardest lol
But not safety demanhandle close
Kam chaheya ji. Hamko sandblasting ka
Very nice and informative
😂
I AM FROM ADVANCE BOLTING SOLUTIONS... TECHNICUAN..
Where are you from?
Kuch batao vaai
How to losen the bolts
Just tension bolts again till nut frees off , but remember to leave gap otherwise you end up with jack stuck on bolt
Unsafe ! Why there is a welding activity near in the Hydrotest area? And where is the barricade?
please call me to have solution best good !
Where is this site location ?
Partex project
Good
What is the brand for this equipment
It's haidrtigh tools
we were testing a piece of piping including some sort of a heat exchanger... there must have been hellova lot of air in the system. We tried to get all the air out but in the end, we pumped a pump just like the one in the video for over an hour non stop. I mean we filled it up at least 20 times.. and we only got up to 6bar. It was ridiculous. But it had to do because we had no time nor means to do anything about it.
Good SA3 Blast that