- Видео 8
- Просмотров 22 490
Think I 3D
Индия
Добавлен 30 дек 2017
View dependent edit in NX 10
This video demonstrates you how to use view dependent edit in NX.
If you have any suggestions or requests please comment below....
If you have any suggestions or requests please comment below....
Просмотров: 6 789
Видео
Creating Knowledge enabled Part in NX
Просмотров 4,8 тыс.6 лет назад
This video demonstrates you about Reuse library, Creating .Krx file
Create Block From Line
Просмотров 1156 лет назад
This Video Shows you How to Create Block From a Line in a single step. and Here the List of all general shortcut keys used in NX: drive.google.com/open?id=187HZ9GL_Z42RwhxvHDFv-BnjJZLM7xcw
Editing Individual Instances in Pattern Featture
Просмотров 2596 лет назад
Describes how to edit individual instances in pattern geometry. This option is useful when we required change parameters and position of individual instances.
Re Attach Sketch in NX 10
Просмотров 3,8 тыс.6 лет назад
Descries how to Reattach sketch from plane to plane or plane to path.
Derived line in NX 10
Просмотров 3 тыс.6 лет назад
Describes how to create line from existing lines. Creates parallel line when single line selected Creates bisector line when two lines(Either parallel or inclined) selected.
Direct sketch and sketch in task environment in NX 10
Просмотров 3,1 тыс.6 лет назад
Describes the difference between Direct sketch and sketch in task environment in NX 10.
Difference between Finish sketch and Exit sketch in NX 10
Просмотров 6806 лет назад
Describes the difference between finish sketch and exit sketch in NX 10.
Also, My eyes aren't that good anymore and every thing is so small.
Slow it down a little and tell what you're doing. Not all of us are experts!
Is there any shortcut to enable the "reattach" feature? or can it be customised?
I am getting an error "The family member saving directory does not exist." I do not have an independent spreadsheet but part families for my part. I chose the required attributes from the part families while creating the krx file. Can you please help me if there is a further step that is required?
First of all spreadsheet is necessary to generate krx file for any component. Next, make sure the folder is not renamed or moved to some other location. And in case if you have part families for any part, there's similar kind of approach to create krx sheet.
Thanks for the reply but I was able to fix it by changing my libraries location and changing my spreadsheet location to where the libraries were saved. Both of them before were in a different location and therefore I received that error. Thanks again.
How to add center line and center line dimensions in detail view
What is difference .?? Explain....We know it is there in nx
Very nice. Thank you. Subscribed.
👌👌👌👌👌👌👌