Видео

@@jonnyfromtheblock1 sure is my brother how you been?

@@joshromeo6036 oh hell yeah, they are 👌👌

@@lrkn7440 mate, I would think about it but the extractors cost me over $1000

@@lrkn7440 they are proper tuned pacemaker L67 extractors

@@lrkn7440 I have a full air to air intercooler plate mishimoto intercooler set up supercharger injectors whole set up to make at least 400rwhp if you’re interested it’s over $3000 worth of stuff though

@@mattrob1483 hell yeah Brother welcome to the Aussie Bogan channel much appreciated

@@dhold44 at the moment mate not in any course I’ve had a shoulder injury and not many places are willing to take me pretty much a liability so just trying to start something with this RUclips channel and open up a garage and hopefully eventually a skid pad so people can take it off the streets

@@aussiebogan1381 ah no good mate, sorry to hear that, well I wish all the best to you legend

@@dhold44 legend my friend all the best to you 🫶🫶

@@JeffBobonYT legend mate thanks for the words of encouragement And can only try mate no one’s perfect 👌

@@yanimamathew223 original 3.8l v6 ecotec engine with work done to it

If it has cams you can cam it

@@ShaneAstley no other way my friend hahah

- Standard crank - Spool forged rods - Jcc cast pistons - Rotating assembly balanced- balance shaft removed - Oil pump with machined cover and high pressure spring - Roll master double row timing chain - Camtech 230/233@50 561/572 lift cam - Anti pump up lifters - 130# pac valve springs/retainers/valve locks - Ported heads-flow just over 200cm - 10.5:1 comp - Cosmetic head gaskets - ARP head and main studs + rod bolts - Ported intake portmatched to heads - 69mm throttle body - Bosch 36 pound injectors - Bosch 044 fuel pump - Surge tank - Full 2 1/2" exhaust (can't remember brand)

In this video it only has rear muffler no centre mufflers

Definitely the 3“ I would recommend going mild-steel just gives it a bit deeper note which you want for a V8 and cheaper unless you’re close to the ocean then go stainless

@@aussiebogan1381 mufflers centre and rear? Currently running 2.5” with centre mufflers and straight pipes in the rear doesn’t sound too good

Check out my 5500rpm two-step video that’s with empire exhaust system extractors higher flow catch 3 inch exhaust with mufflers in the middle and rear

This video it has no middle mufflers and is a different exhaust system

@@aussiebogan1381 I saw that video too but couldn’t make out the exhaust clear enough. Do you get any crackle with the 3” + both mufflers?

if its just a skidder take the rear breaks off completely and cap/pinch the break lines (make sure u tuck them up properly)